diff options
Diffstat (limited to 'drivers/infiniband/hw/ipath/ipath_iba6110.c')
| -rw-r--r-- | drivers/infiniband/hw/ipath/ipath_iba6110.c | 172 |
1 files changed, 156 insertions, 16 deletions
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6110.c b/drivers/infiniband/hw/ipath/ipath_iba6110.c index ac436c630bc..9e2ced3cdc5 100644 --- a/drivers/infiniband/hw/ipath/ipath_iba6110.c +++ b/drivers/infiniband/hw/ipath/ipath_iba6110.c @@ -329,6 +329,9 @@ static const struct ipath_cregs ipath_ht_cregs = { #define INFINIPATH_HWE_HTAPLL_RFSLIP 0x1000000000000000ULL #define INFINIPATH_HWE_SERDESPLLFAILED 0x2000000000000000ULL +#define IBA6110_IBCS_LINKTRAININGSTATE_MASK 0xf +#define IBA6110_IBCS_LINKSTATE_SHIFT 4 + /* kr_extstatus bits */ #define INFINIPATH_EXTS_FREQSEL 0x2 #define INFINIPATH_EXTS_SERDESSEL 0x4 @@ -705,7 +708,6 @@ static int ipath_ht_boardname(struct ipath_devdata *dd, char *name, "with ID %u\n", boardrev); snprintf(name, namelen, "Unknown_InfiniPath_QHT7xxx_%u", boardrev); - ret = 1; break; } if (n) @@ -1137,11 +1139,49 @@ static void ipath_setup_ht_setextled(struct ipath_devdata *dd, static void ipath_init_ht_variables(struct ipath_devdata *dd) { + /* + * setup the register offsets, since they are different for each + * chip + */ + dd->ipath_kregs = &ipath_ht_kregs; + dd->ipath_cregs = &ipath_ht_cregs; + dd->ipath_gpio_sda_num = _IPATH_GPIO_SDA_NUM; dd->ipath_gpio_scl_num = _IPATH_GPIO_SCL_NUM; dd->ipath_gpio_sda = IPATH_GPIO_SDA; dd->ipath_gpio_scl = IPATH_GPIO_SCL; + /* + * Fill in data for field-values that change in newer chips. + * We dynamically specify only the mask for LINKTRAININGSTATE + * and only the shift for LINKSTATE, as they are the only ones + * that change. Also precalculate the 3 link states of interest + * and the combined mask. + */ + dd->ibcs_ls_shift = IBA6110_IBCS_LINKSTATE_SHIFT; + dd->ibcs_lts_mask = IBA6110_IBCS_LINKTRAININGSTATE_MASK; + dd->ibcs_mask = (INFINIPATH_IBCS_LINKSTATE_MASK << + dd->ibcs_ls_shift) | dd->ibcs_lts_mask; + dd->ib_init = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_INIT << dd->ibcs_ls_shift); + dd->ib_arm = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_ARM << dd->ibcs_ls_shift); + dd->ib_active = (INFINIPATH_IBCS_LT_STATE_LINKUP << + INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) | + (INFINIPATH_IBCS_L_STATE_ACTIVE << dd->ibcs_ls_shift); + + /* + * Fill in data for ibcc field-values that change in newer chips. + * We dynamically specify only the mask for LINKINITCMD + * and only the shift for LINKCMD and MAXPKTLEN, as they are + * the only ones that change. + */ + dd->ibcc_lic_mask = INFINIPATH_IBCC_LINKINITCMD_MASK; + dd->ibcc_lc_shift = INFINIPATH_IBCC_LINKCMD_SHIFT; + dd->ibcc_mpl_shift = INFINIPATH_IBCC_MAXPKTLEN_SHIFT; + /* Fill in shifts for RcvCtrl. */ dd->ipath_r_portenable_shift = INFINIPATH_R_PORTENABLE_SHIFT; dd->ipath_r_intravail_shift = INFINIPATH_R_INTRAVAIL_SHIFT; @@ -1204,6 +1244,8 @@ static void ipath_init_ht_variables(struct ipath_devdata *dd) dd->ipath_i_rcvavail_mask = INFINIPATH_I_RCVAVAIL_MASK; dd->ipath_i_rcvurg_mask = INFINIPATH_I_RCVURG_MASK; + dd->ipath_i_rcvavail_shift = INFINIPATH_I_RCVAVAIL_SHIFT; + dd->ipath_i_rcvurg_shift = INFINIPATH_I_RCVURG_SHIFT; /* * EEPROM error log 0 is TXE Parity errors. 1 is RXE Parity. @@ -1217,9 +1259,17 @@ static void ipath_init_ht_variables(struct ipath_devdata *dd) INFINIPATH_HWE_RXEMEMPARITYERR_MASK << INFINIPATH_HWE_RXEMEMPARITYERR_SHIFT; - dd->ipath_eep_st_masks[2].errs_to_log = - INFINIPATH_E_INVALIDADDR | INFINIPATH_E_RESET; + dd->ipath_eep_st_masks[2].errs_to_log = INFINIPATH_E_RESET; + dd->delay_mult = 2; /* SDR, 4X, can't change */ + + dd->ipath_link_width_supported = IB_WIDTH_1X | IB_WIDTH_4X; + dd->ipath_link_speed_supported = IPATH_IB_SDR; + dd->ipath_link_width_enabled = IB_WIDTH_4X; + dd->ipath_link_speed_enabled = dd->ipath_link_speed_supported; + /* these can't change for this chip, so set once */ + dd->ipath_link_width_active = dd->ipath_link_width_enabled; + dd->ipath_link_speed_active = dd->ipath_link_speed_enabled; } /** @@ -1281,6 +1331,9 @@ static void ipath_ht_init_hwerrors(struct ipath_devdata *dd) dd->ipath_hwerrmask = val; } + + + /** * ipath_ht_bringup_serdes - bring up the serdes * @dd: the infinipath device @@ -1439,6 +1492,7 @@ static void ipath_ht_put_tid(struct ipath_devdata *dd, pa |= lenvalid | INFINIPATH_RT_VALID; } } + writeq(pa, tidptr); } @@ -1644,6 +1698,13 @@ static void ipath_ht_free_irq(struct ipath_devdata *dd) dd->ipath_intconfig = 0; } +static struct ipath_message_header * +ipath_ht_get_msgheader(struct ipath_devdata *dd, __le32 *rhf_addr) +{ + return (struct ipath_message_header *) + &rhf_addr[sizeof(u64) / sizeof(u32)]; +} + static void ipath_ht_config_ports(struct ipath_devdata *dd, ushort cfgports) { dd->ipath_portcnt = @@ -1757,6 +1818,90 @@ static void ipath_ht_read_counters(struct ipath_devdata *dd, cntrs->RxDlidFltrCnt = 0; } + +/* no interrupt fallback for these chips */ +static int ipath_ht_nointr_fallback(struct ipath_devdata *dd) +{ + return 0; +} + + +/* + * reset the XGXS (between serdes and IBC). Slightly less intrusive + * than resetting the IBC or external link state, and useful in some + * cases to cause some retraining. To do this right, we reset IBC + * as well. + */ +static void ipath_ht_xgxs_reset(struct ipath_devdata *dd) +{ + u64 val, prev_val; + + prev_val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_xgxsconfig); + val = prev_val | INFINIPATH_XGXS_RESET; + prev_val &= ~INFINIPATH_XGXS_RESET; /* be sure */ + ipath_write_kreg(dd, dd->ipath_kregs->kr_control, + dd->ipath_control & ~INFINIPATH_C_LINKENABLE); + ipath_write_kreg(dd, dd->ipath_kregs->kr_xgxsconfig, val); + ipath_read_kreg32(dd, dd->ipath_kregs->kr_scratch); + ipath_write_kreg(dd, dd->ipath_kregs->kr_xgxsconfig, prev_val); + ipath_write_kreg(dd, dd->ipath_kregs->kr_control, + dd->ipath_control); +} + + +static int ipath_ht_get_ib_cfg(struct ipath_devdata *dd, int which) +{ + int ret; + + switch (which) { + case IPATH_IB_CFG_LWID: + ret = dd->ipath_link_width_active; + break; + case IPATH_IB_CFG_SPD: + ret = dd->ipath_link_speed_active; + break; + case IPATH_IB_CFG_LWID_ENB: + ret = dd->ipath_link_width_enabled; + break; + case IPATH_IB_CFG_SPD_ENB: + ret = dd->ipath_link_speed_enabled; + break; + default: + ret = -ENOTSUPP; + break; + } + return ret; +} + + +/* we assume range checking is already done, if needed */ +static int ipath_ht_set_ib_cfg(struct ipath_devdata *dd, int which, u32 val) +{ + int ret = 0; + + if (which == IPATH_IB_CFG_LWID_ENB) + dd->ipath_link_width_enabled = val; + else if (which == IPATH_IB_CFG_SPD_ENB) + dd->ipath_link_speed_enabled = val; + else + ret = -ENOTSUPP; + return ret; +} + + +static void ipath_ht_config_jint(struct ipath_devdata *dd, u16 a, u16 b) +{ +} + + +static int ipath_ht_ib_updown(struct ipath_devdata *dd, int ibup, u64 ibcs) +{ + ipath_setup_ht_setextled(dd, ipath_ib_linkstate(dd, ibcs), + ipath_ib_linktrstate(dd, ibcs)); + return 0; +} + + /** * ipath_init_iba6110_funcs - set up the chip-specific function pointers * @dd: the infinipath device @@ -1781,24 +1926,19 @@ void ipath_init_iba6110_funcs(struct ipath_devdata *dd) dd->ipath_f_setextled = ipath_setup_ht_setextled; dd->ipath_f_get_base_info = ipath_ht_get_base_info; dd->ipath_f_free_irq = ipath_ht_free_irq; + dd->ipath_f_tidtemplate = ipath_ht_tidtemplate; + dd->ipath_f_intr_fallback = ipath_ht_nointr_fallback; + dd->ipath_f_get_msgheader = ipath_ht_get_msgheader; dd->ipath_f_config_ports = ipath_ht_config_ports; dd->ipath_f_read_counters = ipath_ht_read_counters; + dd->ipath_f_xgxs_reset = ipath_ht_xgxs_reset; + dd->ipath_f_get_ib_cfg = ipath_ht_get_ib_cfg; + dd->ipath_f_set_ib_cfg = ipath_ht_set_ib_cfg; + dd->ipath_f_config_jint = ipath_ht_config_jint; + dd->ipath_f_ib_updown = ipath_ht_ib_updown; /* * initialize chip-specific variables */ - dd->ipath_f_tidtemplate = ipath_ht_tidtemplate; - - /* - * setup the register offsets, since they are different for each - * chip - */ - dd->ipath_kregs = &ipath_ht_kregs; - dd->ipath_cregs = &ipath_ht_cregs; - - /* - * do very early init that is needed before ipath_f_bus is - * called - */ ipath_init_ht_variables(dd); } |