diff options
Diffstat (limited to 'arch/unicore32/kernel/head.S')
| -rw-r--r-- | arch/unicore32/kernel/head.S | 252 |
1 files changed, 252 insertions, 0 deletions
diff --git a/arch/unicore32/kernel/head.S b/arch/unicore32/kernel/head.S new file mode 100644 index 00000000000..92255f3ab6a --- /dev/null +++ b/arch/unicore32/kernel/head.S @@ -0,0 +1,252 @@ +/* + * linux/arch/unicore32/kernel/head.S + * + * Code specific to PKUnity SoC and UniCore ISA + * + * Copyright (C) 2001-2010 GUAN Xue-tao + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + */ +#include <linux/linkage.h> +#include <linux/init.h> + +#include <asm/assembler.h> +#include <asm/ptrace.h> +#include <generated/asm-offsets.h> +#include <asm/memory.h> +#include <asm/thread_info.h> +#include <asm/system.h> +#include <asm/pgtable-hwdef.h> + +#if (PHYS_OFFSET & 0x003fffff) +#error "PHYS_OFFSET must be at an even 4MiB boundary!" +#endif + +#define KERNEL_RAM_VADDR (PAGE_OFFSET + KERNEL_IMAGE_START) +#define KERNEL_RAM_PADDR (PHYS_OFFSET + KERNEL_IMAGE_START) + +#define KERNEL_PGD_PADDR (KERNEL_RAM_PADDR - 0x1000) +#define KERNEL_PGD_VADDR (KERNEL_RAM_VADDR - 0x1000) + +#define KERNEL_START KERNEL_RAM_VADDR +#define KERNEL_END _end + +/* + * swapper_pg_dir is the virtual address of the initial page table. + * We place the page tables 4K below KERNEL_RAM_VADDR. Therefore, we must + * make sure that KERNEL_RAM_VADDR is correctly set. Currently, we expect + * the least significant 16 bits to be 0x8000, but we could probably + * relax this restriction to KERNEL_RAM_VADDR >= PAGE_OFFSET + 0x1000. + */ +#if (KERNEL_RAM_VADDR & 0xffff) != 0x8000 +#error KERNEL_RAM_VADDR must start at 0xXXXX8000 +#endif + + .globl swapper_pg_dir + .equ swapper_pg_dir, KERNEL_RAM_VADDR - 0x1000 + +/* + * Kernel startup entry point. + * --------------------------- + * + * This is normally called from the decompressor code. The requirements + * are: MMU = off, D-cache = off, I-cache = dont care + * + * This code is mostly position independent, so if you link the kernel at + * 0xc0008000, you call this at __pa(0xc0008000). + */ + __HEAD +ENTRY(stext) + @ set asr + mov r0, #PRIV_MODE @ ensure priv mode + or r0, #PSR_R_BIT | PSR_I_BIT @ disable irqs + mov.a asr, r0 + + @ process identify + movc r0, p0.c0, #0 @ cpuid + movl r1, 0xff00ffff @ mask + movl r2, 0x4d000863 @ value + and r0, r1, r0 + cxor.a r0, r2 + bne __error_p @ invalid processor id + + /* + * Clear the 4K level 1 swapper page table + */ + movl r0, #KERNEL_PGD_PADDR @ page table address + mov r1, #0 + add r2, r0, #0x1000 +101: stw.w r1, [r0]+, #4 + stw.w r1, [r0]+, #4 + stw.w r1, [r0]+, #4 + stw.w r1, [r0]+, #4 + cxor.a r0, r2 + bne 101b + + movl r4, #KERNEL_PGD_PADDR @ page table address + mov r7, #PMD_TYPE_SECT | PMD_PRESENT @ page size: section + or r7, r7, #PMD_SECT_CACHEABLE @ cacheable + or r7, r7, #PMD_SECT_READ | PMD_SECT_WRITE | PMD_SECT_EXEC + + /* + * Create identity mapping for first 4MB of kernel to + * cater for the MMU enable. This identity mapping + * will be removed by paging_init(). We use our current program + * counter to determine corresponding section base address. + */ + mov r6, pc + mov r6, r6 >> #22 @ start of kernel section + or r1, r7, r6 << #22 @ flags + kernel base + stw r1, [r4+], r6 << #2 @ identity mapping + + /* + * Now setup the pagetables for our kernel direct + * mapped region. + */ + add r0, r4, #(KERNEL_START & 0xff000000) >> 20 + stw.w r1, [r0+], #(KERNEL_START & 0x00c00000) >> 20 + movl r6, #(KERNEL_END - 1) + add r0, r0, #4 + add r6, r4, r6 >> #20 +102: csub.a r0, r6 + add r1, r1, #1 << 22 + bua 103f + stw.w r1, [r0]+, #4 + b 102b +103: + /* + * Then map first 4MB of ram in case it contains our boot params. + */ + add r0, r4, #PAGE_OFFSET >> 20 + or r6, r7, #(PHYS_OFFSET & 0xffc00000) + stw r6, [r0] + + ldw r15, __switch_data @ address to jump to after + + /* + * Initialise TLB, Caches, and MMU state ready to switch the MMU + * on. + */ + mov r0, #0 + movc p0.c5, r0, #28 @ cache invalidate all + nop8 + movc p0.c6, r0, #6 @ TLB invalidate all + nop8 + + /* + * ..V. .... ..TB IDAM + * ..1. .... ..01 1111 + */ + movl r0, #0x201f @ control register setting + + /* + * Setup common bits before finally enabling the MMU. Essentially + * this is just loading the page table pointer and domain access + * registers. + */ + #ifndef CONFIG_ALIGNMENT_TRAP + andn r0, r0, #CR_A + #endif + #ifdef CONFIG_CPU_DCACHE_DISABLE + andn r0, r0, #CR_D + #endif + #ifdef CONFIG_CPU_DCACHE_WRITETHROUGH + andn r0, r0, #CR_B + #endif + #ifdef CONFIG_CPU_ICACHE_DISABLE + andn r0, r0, #CR_I + #endif + + movc p0.c2, r4, #0 @ set pgd + b __turn_mmu_on +ENDPROC(stext) + +/* + * Enable the MMU. This completely changes the stucture of the visible + * memory space. You will not be able to trace execution through this. + * + * r0 = cp#0 control register + * r15 = *virtual* address to jump to upon completion + */ + .align 5 +__turn_mmu_on: + mov r0, r0 + movc p0.c1, r0, #0 @ write control reg + nop @ fetch inst by phys addr + mov pc, r15 + nop8 @ fetch inst by phys addr +ENDPROC(__turn_mmu_on) + +/* + * Setup the initial page tables. We only setup the barest + * amount which are required to get the kernel running, which + * generally means mapping in the kernel code. + * + * r9 = cpuid + * r10 = procinfo + * + * Returns: + * r0, r3, r6, r7 corrupted + * r4 = physical page table address + */ + .ltorg + + .align 2 + .type __switch_data, %object +__switch_data: + .long __mmap_switched + .long __bss_start @ r6 + .long _end @ r7 + .long cr_alignment @ r8 + .long init_thread_union + THREAD_START_SP @ sp + +/* + * The following fragment of code is executed with the MMU on in MMU mode, + * and uses absolute addresses; this is not position independent. + * + * r0 = cp#0 control register + */ +__mmap_switched: + adr r3, __switch_data + 4 + + ldm.w (r6, r7, r8), [r3]+ + ldw sp, [r3] + + mov fp, #0 @ Clear BSS (and zero fp) +203: csub.a r6, r7 + bea 204f + stw.w fp, [r6]+,#4 + b 203b +204: + andn r1, r0, #CR_A @ Clear 'A' bit + stm (r0, r1), [r8]+ @ Save control register values + b start_kernel +ENDPROC(__mmap_switched) + +/* + * Exception handling. Something went wrong and we can't proceed. We + * ought to tell the user, but since we don't have any guarantee that + * we're even running on the right architecture, we do virtually nothing. + * + * If CONFIG_DEBUG_LL is set we try to print out something about the error + * and hope for the best (useful if bootloader fails to pass a proper + * machine ID for example). + */ +__error_p: +#ifdef CONFIG_DEBUG_LL + adr r0, str_p1 + b.l printascii + mov r0, r9 + b.l printhex8 + adr r0, str_p2 + b.l printascii +901: nop8 + b 901b +str_p1: .asciz "\nError: unrecognized processor variant (0x" +str_p2: .asciz ").\n" + .align +#endif +ENDPROC(__error_p) + |