diff options
Diffstat (limited to 'arch/tile/kernel/setup.c')
| -rw-r--r-- | arch/tile/kernel/setup.c | 28 |
1 files changed, 16 insertions, 12 deletions
diff --git a/arch/tile/kernel/setup.c b/arch/tile/kernel/setup.c index c1a697e6854..6444a2bbe1a 100644 --- a/arch/tile/kernel/setup.c +++ b/arch/tile/kernel/setup.c @@ -187,11 +187,11 @@ early_param("vmalloc", parse_vmalloc); #ifdef CONFIG_HIGHMEM /* - * Determine for each controller where its lowmem is mapped and how - * much of it is mapped there. On controller zero, the first few - * megabytes are mapped at 0xfd000000 as code, so in principle we - * could start our data mappings higher up, but for now we don't - * bother, to avoid additional confusion. + * Determine for each controller where its lowmem is mapped and how much of + * it is mapped there. On controller zero, the first few megabytes are + * already mapped in as code at MEM_SV_INTRPT, so in principle we could + * start our data mappings higher up, but for now we don't bother, to avoid + * additional confusion. * * One question is whether, on systems with more than 768 Mb and * controllers of different sizes, to map in a proportionate amount of @@ -876,6 +876,9 @@ void __cpuinit setup_cpu(int boot) #if CHIP_HAS_SN_PROC() raw_local_irq_unmask(INT_SNITLB_MISS); #endif +#ifdef __tilegx__ + raw_local_irq_unmask(INT_SINGLE_STEP_K); +#endif /* * Allow user access to many generic SPRs, like the cycle @@ -893,11 +896,12 @@ void __cpuinit setup_cpu(int boot) #endif /* - * Set the MPL for interrupt control 0 to user level. - * This includes access to the SYSTEM_SAVE and EX_CONTEXT SPRs, - * as well as the PL 0 interrupt mask. + * Set the MPL for interrupt control 0 & 1 to the corresponding + * values. This includes access to the SYSTEM_SAVE and EX_CONTEXT + * SPRs, as well as the interrupt mask. */ __insn_mtspr(SPR_MPL_INTCTRL_0_SET_0, 1); + __insn_mtspr(SPR_MPL_INTCTRL_1_SET_1, 1); /* Initialize IRQ support for this cpu. */ setup_irq_regs(); @@ -1033,7 +1037,7 @@ static void __init validate_va(void) * In addition, make sure we CAN'T use the end of memory, since * we use the last chunk of each pgd for the pgd_list. */ - int i, fc_fd_ok = 0; + int i, user_kernel_ok = 0; unsigned long max_va = 0; unsigned long list_va = ((PGD_LIST_OFFSET / sizeof(pgd_t)) << PGDIR_SHIFT); @@ -1044,13 +1048,13 @@ static void __init validate_va(void) break; if (range.start <= MEM_USER_INTRPT && range.start + range.size >= MEM_HV_INTRPT) - fc_fd_ok = 1; + user_kernel_ok = 1; if (range.start == 0) max_va = range.size; BUG_ON(range.start + range.size > list_va); } - if (!fc_fd_ok) - early_panic("Hypervisor not configured for VAs 0xfc/0xfd\n"); + if (!user_kernel_ok) + early_panic("Hypervisor not configured for user/kernel VAs\n"); if (max_va == 0) early_panic("Hypervisor not configured for low VAs\n"); if (max_va < KERNEL_HIGH_VADDR) |