diff options
Diffstat (limited to 'arch/mips/alchemy/devboards/db1x00/board_setup.c')
| -rw-r--r-- | arch/mips/alchemy/devboards/db1x00/board_setup.c | 204 |
1 files changed, 155 insertions, 49 deletions
diff --git a/arch/mips/alchemy/devboards/db1x00/board_setup.c b/arch/mips/alchemy/devboards/db1x00/board_setup.c index de30d8ea717..50c9bef99da 100644 --- a/arch/mips/alchemy/devboards/db1x00/board_setup.c +++ b/arch/mips/alchemy/devboards/db1x00/board_setup.c @@ -29,59 +29,139 @@ #include <linux/gpio.h> #include <linux/init.h> +#include <linux/interrupt.h> +#include <linux/pm.h> #include <asm/mach-au1x00/au1000.h> +#include <asm/mach-au1x00/au1xxx_eth.h> #include <asm/mach-db1x00/db1x00.h> +#include <asm/mach-db1x00/bcsr.h> +#include <asm/reboot.h> #include <prom.h> +#ifdef CONFIG_MIPS_DB1500 +char irq_tab_alchemy[][5] __initdata = { + [12] = { -1, AU1500_PCI_INTA, 0xff, 0xff, 0xff }, /* IDSEL 12 - HPT371 */ + [13] = { -1, AU1500_PCI_INTA, AU1500_PCI_INTB, AU1500_PCI_INTC, AU1500_PCI_INTD }, /* IDSEL 13 - PCI slot */ +}; + +#endif -static BCSR * const bcsr = (BCSR *)BCSR_KSEG1_ADDR; + +#ifdef CONFIG_MIPS_DB1550 +char irq_tab_alchemy[][5] __initdata = { + [11] = { -1, AU1550_PCI_INTC, 0xff, 0xff, 0xff }, /* IDSEL 11 - on-board HPT371 */ + [12] = { -1, AU1550_PCI_INTB, AU1550_PCI_INTC, AU1550_PCI_INTD, AU1550_PCI_INTA }, /* IDSEL 12 - PCI slot 2 (left) */ + [13] = { -1, AU1550_PCI_INTA, AU1550_PCI_INTB, AU1550_PCI_INTC, AU1550_PCI_INTD }, /* IDSEL 13 - PCI slot 1 (right) */ +}; +#endif + + +#ifdef CONFIG_MIPS_BOSPORUS +char irq_tab_alchemy[][5] __initdata = { + [11] = { -1, AU1500_PCI_INTA, AU1500_PCI_INTB, 0xff, 0xff }, /* IDSEL 11 - miniPCI */ + [12] = { -1, AU1500_PCI_INTA, 0xff, 0xff, 0xff }, /* IDSEL 12 - SN1741 */ + [13] = { -1, AU1500_PCI_INTA, AU1500_PCI_INTB, AU1500_PCI_INTC, AU1500_PCI_INTD }, /* IDSEL 13 - PCI slot */ +}; + +/* + * Micrel/Kendin 5 port switch attached to MAC0, + * MAC0 is associated with PHY address 5 (== WAN port) + * MAC1 is not associated with any PHY, since it's connected directly + * to the switch. + * no interrupts are used + */ +static struct au1000_eth_platform_data eth0_pdata = { + .phy_static_config = 1, + .phy_addr = 5, +}; + +static void bosporus_power_off(void) +{ + printk(KERN_INFO "It's now safe to turn off power\n"); + while (1) + asm volatile (".set mips3 ; wait ; .set mips0"); +} const char *get_system_type(void) { -#ifdef CONFIG_MIPS_BOSPORUS return "Alchemy Bosporus Gateway Reference"; -#else - return "Alchemy Db1x00"; +} #endif + + +#ifdef CONFIG_MIPS_MIRAGE +char irq_tab_alchemy[][5] __initdata = { + [11] = { -1, AU1500_PCI_INTD, 0xff, 0xff, 0xff }, /* IDSEL 11 - SMI VGX */ + [12] = { -1, 0xff, 0xff, AU1500_PCI_INTC, 0xff }, /* IDSEL 12 - PNX1300 */ + [13] = { -1, AU1500_PCI_INTA, AU1500_PCI_INTB, 0xff, 0xff }, /* IDSEL 13 - miniPCI */ +}; + +static void mirage_power_off(void) +{ + alchemy_gpio_direction_output(210, 1); +} + +const char *get_system_type(void) +{ + return "Alchemy Mirage"; +} +#endif + + +#if defined(CONFIG_MIPS_BOSPORUS) || defined(CONFIG_MIPS_MIRAGE) +static void mips_softreset(void) +{ + asm volatile ("jr\t%0" : : "r"(0xbfc00000)); } -void board_reset(void) +#else + +const char *get_system_type(void) { - /* Hit BCSR.SW_RESET[RESET] */ - bcsr->swreset = 0x0000; + return "Alchemy Db1x00"; } +#endif + void __init board_setup(void) { - u32 pin_func = 0; - char *argptr; - - argptr = prom_getcmdline(); -#ifdef CONFIG_SERIAL_8250_CONSOLE - argptr = strstr(argptr, "console="); - if (argptr == NULL) { - argptr = prom_getcmdline(); - strcat(argptr, " console=ttyS0,115200"); - } + unsigned long bcsr1, bcsr2; + u32 pin_func; + + bcsr1 = DB1000_BCSR_PHYS_ADDR; + bcsr2 = DB1000_BCSR_PHYS_ADDR + DB1000_BCSR_HEXLED_OFS; + + pin_func = 0; + +#ifdef CONFIG_MIPS_DB1000 + printk(KERN_INFO "AMD Alchemy Au1000/Db1000 Board\n"); +#endif +#ifdef CONFIG_MIPS_DB1500 + printk(KERN_INFO "AMD Alchemy Au1500/Db1500 Board\n"); #endif +#ifdef CONFIG_MIPS_DB1100 + printk(KERN_INFO "AMD Alchemy Au1100/Db1100 Board\n"); +#endif +#ifdef CONFIG_MIPS_BOSPORUS + au1xxx_override_eth_cfg(0, ð0_pdata); -#ifdef CONFIG_FB_AU1100 - argptr = strstr(argptr, "video="); - if (argptr == NULL) { - argptr = prom_getcmdline(); - /* default panel */ - /*strcat(argptr, " video=au1100fb:panel:Sharp_320x240_16");*/ - } + printk(KERN_INFO "AMD Alchemy Bosporus Board\n"); #endif +#ifdef CONFIG_MIPS_MIRAGE + printk(KERN_INFO "AMD Alchemy Mirage Board\n"); +#endif +#ifdef CONFIG_MIPS_DB1550 + printk(KERN_INFO "AMD Alchemy Au1550/Db1550 Board\n"); -#if defined(CONFIG_SOUND_AU1X00) && !defined(CONFIG_SOC_AU1000) - /* au1000 does not support vra, au1500 and au1100 do */ - strcat(argptr, " au1000_audio=vra"); - argptr = prom_getcmdline(); + bcsr1 = DB1550_BCSR_PHYS_ADDR; + bcsr2 = DB1550_BCSR_PHYS_ADDR + DB1550_BCSR_HEXLED_OFS; #endif + /* initialize board register space */ + bcsr_init(bcsr1, bcsr2); + /* Not valid for Au1550 */ #if defined(CONFIG_IRDA) && \ (defined(CONFIG_SOC_AU1000) || defined(CONFIG_SOC_AU1100)) @@ -89,11 +169,10 @@ void __init board_setup(void) pin_func = au_readl(SYS_PINFUNC) | SYS_PF_IRF; au_writel(pin_func, SYS_PINFUNC); /* Power off until the driver is in use */ - bcsr->resets &= ~BCSR_RESETS_IRDA_MODE_MASK; - bcsr->resets |= BCSR_RESETS_IRDA_MODE_OFF; - au_sync(); + bcsr_mod(BCSR_RESETS, BCSR_RESETS_IRDA_MODE_MASK, + BCSR_RESETS_IRDA_MODE_OFF); #endif - bcsr->pcmcia = 0x0000; /* turn off PCMCIA power */ + bcsr_write(BCSR_PCMCIA, 0); /* turn off PCMCIA power */ /* Enable GPIO[31:0] inputs */ alchemy_gpio1_input_enable(); @@ -120,26 +199,53 @@ void __init board_setup(void) * be part of the audio driver. */ alchemy_gpio_direction_output(209, 1); -#endif - - au_sync(); -#ifdef CONFIG_MIPS_DB1000 - printk(KERN_INFO "AMD Alchemy Au1000/Db1000 Board\n"); -#endif -#ifdef CONFIG_MIPS_DB1500 - printk(KERN_INFO "AMD Alchemy Au1500/Db1500 Board\n"); -#endif -#ifdef CONFIG_MIPS_DB1100 - printk(KERN_INFO "AMD Alchemy Au1100/Db1100 Board\n"); + pm_power_off = mirage_power_off; + _machine_halt = mirage_power_off; + _machine_restart = (void(*)(char *))mips_softreset; #endif + #ifdef CONFIG_MIPS_BOSPORUS - printk(KERN_INFO "AMD Alchemy Bosporus Board\n"); + pm_power_off = bosporus_power_off; + _machine_halt = bosporus_power_off; + _machine_restart = (void(*)(char *))mips_softreset; #endif -#ifdef CONFIG_MIPS_MIRAGE - printk(KERN_INFO "AMD Alchemy Mirage Board\n"); -#endif -#ifdef CONFIG_MIPS_DB1550 - printk(KERN_INFO "AMD Alchemy Au1550/Db1550 Board\n"); + au_sync(); +} + +static int __init db1x00_init_irq(void) +{ +#if defined(CONFIG_MIPS_MIRAGE) + set_irq_type(AU1500_GPIO7_INT, IRQF_TRIGGER_RISING); /* TS pendown */ +#elif defined(CONFIG_MIPS_DB1550) + set_irq_type(AU1550_GPIO0_INT, IRQF_TRIGGER_LOW); /* CD0# */ + set_irq_type(AU1550_GPIO1_INT, IRQF_TRIGGER_LOW); /* CD1# */ + set_irq_type(AU1550_GPIO3_INT, IRQF_TRIGGER_LOW); /* CARD0# */ + set_irq_type(AU1550_GPIO5_INT, IRQF_TRIGGER_LOW); /* CARD1# */ + set_irq_type(AU1550_GPIO21_INT, IRQF_TRIGGER_LOW); /* STSCHG0# */ + set_irq_type(AU1550_GPIO22_INT, IRQF_TRIGGER_LOW); /* STSCHG1# */ +#elif defined(CONFIG_MIPS_DB1500) + set_irq_type(AU1500_GPIO0_INT, IRQF_TRIGGER_LOW); /* CD0# */ + set_irq_type(AU1500_GPIO3_INT, IRQF_TRIGGER_LOW); /* CD1# */ + set_irq_type(AU1500_GPIO2_INT, IRQF_TRIGGER_LOW); /* CARD0# */ + set_irq_type(AU1500_GPIO5_INT, IRQF_TRIGGER_LOW); /* CARD1# */ + set_irq_type(AU1500_GPIO1_INT, IRQF_TRIGGER_LOW); /* STSCHG0# */ + set_irq_type(AU1500_GPIO4_INT, IRQF_TRIGGER_LOW); /* STSCHG1# */ +#elif defined(CONFIG_MIPS_DB1100) + set_irq_type(AU1100_GPIO0_INT, IRQF_TRIGGER_LOW); /* CD0# */ + set_irq_type(AU1100_GPIO3_INT, IRQF_TRIGGER_LOW); /* CD1# */ + set_irq_type(AU1100_GPIO2_INT, IRQF_TRIGGER_LOW); /* CARD0# */ + set_irq_type(AU1100_GPIO5_INT, IRQF_TRIGGER_LOW); /* CARD1# */ + set_irq_type(AU1100_GPIO1_INT, IRQF_TRIGGER_LOW); /* STSCHG0# */ + set_irq_type(AU1100_GPIO4_INT, IRQF_TRIGGER_LOW); /* STSCHG1# */ +#elif defined(CONFIG_MIPS_DB1000) + set_irq_type(AU1000_GPIO0_INT, IRQF_TRIGGER_LOW); /* CD0# */ + set_irq_type(AU1000_GPIO3_INT, IRQF_TRIGGER_LOW); /* CD1# */ + set_irq_type(AU1000_GPIO2_INT, IRQF_TRIGGER_LOW); /* CARD0# */ + set_irq_type(AU1000_GPIO5_INT, IRQF_TRIGGER_LOW); /* CARD1# */ + set_irq_type(AU1000_GPIO1_INT, IRQF_TRIGGER_LOW); /* STSCHG0# */ + set_irq_type(AU1000_GPIO4_INT, IRQF_TRIGGER_LOW); /* STSCHG1# */ #endif + return 0; } +arch_initcall(db1x00_init_irq); |