diff options
Diffstat (limited to 'arch/arm/plat-samsung/include/plat/gpio-cfg.h')
| -rw-r--r-- | arch/arm/plat-samsung/include/plat/gpio-cfg.h | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/arch/arm/plat-samsung/include/plat/gpio-cfg.h b/arch/arm/plat-samsung/include/plat/gpio-cfg.h index 5e04fa6eda7..1762dcb4cb9 100644 --- a/arch/arm/plat-samsung/include/plat/gpio-cfg.h +++ b/arch/arm/plat-samsung/include/plat/gpio-cfg.h @@ -125,7 +125,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr, * * These values control the state of the weak pull-{up,down} resistors * available on most pins on the S3C series. Not all chips support both - * up or down settings, and it may be dependant on the chip that is being + * up or down settings, and it may be dependent on the chip that is being * used to whether the particular mode is available. */ #define S3C_GPIO_PULL_NONE ((__force s3c_gpio_pull_t)0x00) @@ -138,7 +138,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr, * @pull: The configuration for the pull resistor. * * This function sets the state of the pull-{up,down} resistor for the - * specified pin. It will return 0 if successfull, or a negative error + * specified pin. It will return 0 if successful, or a negative error * code if the pin cannot support the requested pull setting. * * @pull is one of S3C_GPIO_PULL_NONE, S3C_GPIO_PULL_DOWN or S3C_GPIO_PULL_UP. @@ -202,7 +202,7 @@ extern s5p_gpio_drvstr_t s5p_gpio_get_drvstr(unsigned int pin); * @drvstr: The new value of the driver strength * * This function sets the driver strength value for the specified pin. - * It will return 0 if successfull, or a negative error code if the pin + * It will return 0 if successful, or a negative error code if the pin * cannot support the requested setting. */ extern int s5p_gpio_set_drvstr(unsigned int pin, s5p_gpio_drvstr_t drvstr); |