diff options
Diffstat (limited to 'arch/arm/mach-davinci/include/mach/spi.h')
| -rw-r--r-- | arch/arm/mach-davinci/include/mach/spi.h | 52 |
1 files changed, 46 insertions, 6 deletions
diff --git a/arch/arm/mach-davinci/include/mach/spi.h b/arch/arm/mach-davinci/include/mach/spi.h index 910efbf099c..38f4da5ca13 100644 --- a/arch/arm/mach-davinci/include/mach/spi.h +++ b/arch/arm/mach-davinci/include/mach/spi.h @@ -19,26 +19,66 @@ #ifndef __ARCH_ARM_DAVINCI_SPI_H #define __ARCH_ARM_DAVINCI_SPI_H +#define SPI_INTERN_CS 0xFF + enum { SPI_VERSION_1, /* For DM355/DM365/DM6467 */ SPI_VERSION_2, /* For DA8xx */ }; +/** + * davinci_spi_platform_data - Platform data for SPI master device on DaVinci + * + * @version: version of the SPI IP. Different DaVinci devices have slightly + * varying versions of the same IP. + * @num_chipselect: number of chipselects supported by this SPI master + * @intr_line: interrupt line used to connect the SPI IP to the ARM interrupt + * controller withn the SoC. Possible values are 0 and 1. + * @chip_sel: list of GPIOs which can act as chip-selects for the SPI. + * SPI_INTERN_CS denotes internal SPI chip-select. Not necessary + * to populate if all chip-selects are internal. + * @cshold_bug: set this to true if the SPI controller on your chip requires + * a write to CSHOLD bit in between transfers (like in DM355). + */ struct davinci_spi_platform_data { u8 version; u8 num_chipselect; + u8 intr_line; + u8 *chip_sel; + bool cshold_bug; +}; + +/** + * davinci_spi_config - Per-chip-select configuration for SPI slave devices + * + * @wdelay: amount of delay between transmissions. Measured in number of + * SPI module clocks. + * @odd_parity: polarity of parity flag at the end of transmit data stream. + * 0 - odd parity, 1 - even parity. + * @parity_enable: enable transmission of parity at end of each transmit + * data stream. + * @io_type: type of IO transfer. Choose between polled, interrupt and DMA. + * @timer_disable: disable chip-select timers (setup and hold) + * @c2tdelay: chip-select setup time. Measured in number of SPI module clocks. + * @t2cdelay: chip-select hold time. Measured in number of SPI module clocks. + * @t2edelay: transmit data finished to SPI ENAn pin inactive time. Measured + * in number of SPI clocks. + * @c2edelay: chip-select active to SPI ENAn signal active time. Measured in + * number of SPI clocks. + */ +struct davinci_spi_config { u8 wdelay; u8 odd_parity; u8 parity_enable; - u8 wait_enable; +#define SPI_IO_TYPE_INTR 0 +#define SPI_IO_TYPE_POLL 1 +#define SPI_IO_TYPE_DMA 2 + u8 io_type; u8 timer_disable; - u8 clk_internal; - u8 cs_hold; - u8 intr_level; - u8 poll_mode; - u8 use_dma; u8 c2tdelay; u8 t2cdelay; + u8 t2edelay; + u8 c2edelay; }; #endif /* __ARCH_ARM_DAVINCI_SPI_H */ |