4 files changed, 4 insertions, 4 deletions
diff --git a/Documentation/scsi/aic7xxx.txt b/Documentation/scsi/aic7xxx.txt
index 9b894f116d9..5f34d2ba69b 100644
--- a/Documentation/scsi/aic7xxx.txt
+++ b/Documentation/scsi/aic7xxx.txt
@@ -40,7 +40,7 @@ The following information is available in this file:
    2.   Multi-function Twin Channel Device - Two controllers on one chip.
    3.   Command Channel Secondary DMA Engine - Allows scatter gather list
         and SCB prefetch.
-   4.   64 Byte SCB Support - Allows disconnected, unttagged request table
+   4.   64 Byte SCB Support - Allows disconnected, untagged request table
         for all possible target/lun combinations.
    5.   Block Move Instruction Support - Doubles the speed of certain
         sequencer operations.
diff --git a/Documentation/scsi/aic7xxx_old.txt b/Documentation/scsi/aic7xxx_old.txt
index 05667e7308d..7bd210ab45a 100644
--- a/Documentation/scsi/aic7xxx_old.txt
+++ b/Documentation/scsi/aic7xxx_old.txt
@@ -356,7 +356,7 @@ linux-1.1.x and fairly stable since linux-1.2.x, and are also in FreeBSD
         or enable Tagged Command Queueing (TCQ) on specific devices.  As of
 	driver version 5.1.11, TCQ is now either on or off by default
 	according to the setting you choose during the make config process.
-	In order to en/disable TCQ for certian devices at boot time, a user
+	In order to en/disable TCQ for certain devices at boot time, a user
 	may use this boot param.  The driver will then parse this message out
         and en/disable the specific device entries that are present based upon
         the value given.  The param line is parsed in the following manner:
diff --git a/Documentation/scsi/ncr53c8xx.txt b/Documentation/scsi/ncr53c8xx.txt
index 88ef88b949f..39d409a8efe 100644
--- a/Documentation/scsi/ncr53c8xx.txt
+++ b/Documentation/scsi/ncr53c8xx.txt
@@ -1260,7 +1260,7 @@ then the request of the IRQ obviously will not succeed for all the drivers.
 15.1 Problem tracking
 
 Most SCSI problems are due to a non conformant SCSI bus or to buggy
-devices.  If infortunately you have SCSI problems, you can check the
+devices.  If unfortunately you have SCSI problems, you can check the
 following things:
 
 - SCSI bus cables
diff --git a/Documentation/scsi/sym53c8xx_2.txt b/Documentation/scsi/sym53c8xx_2.txt
index 2c1745a9df0..3d9f06bb3d0 100644
--- a/Documentation/scsi/sym53c8xx_2.txt
+++ b/Documentation/scsi/sym53c8xx_2.txt
@@ -587,7 +587,7 @@ devices, ... may cause a SCSI signal to be wrong when te driver reads it.
 15.1 Problem tracking
 
 Most SCSI problems are due to a non conformant SCSI bus or too buggy
-devices.  If infortunately you have SCSI problems, you can check the
+devices.  If unfortunately you have SCSI problems, you can check the
 following things:
 
 - SCSI bus cables