1 files changed, 57 insertions, 0 deletions
diff --git a/Documentation/networking/netconsole.txt b/Documentation/networking/netconsole.txt
new file mode 100644
index 00000000000..53618fb1a71
--- /dev/null
+++ b/Documentation/networking/netconsole.txt
@@ -0,0 +1,57 @@
+
+started by Ingo Molnar <mingo@redhat.com>, 2001.09.17
+2.6 port and netpoll api by Matt Mackall <mpm@selenic.com>, Sep 9 2003
+
+Please send bug reports to Matt Mackall <mpm@selenic.com>
+
+This module logs kernel printk messages over UDP allowing debugging of
+problem where disk logging fails and serial consoles are impractical.
+
+It can be used either built-in or as a module. As a built-in,
+netconsole initializes immediately after NIC cards and will bring up
+the specified interface as soon as possible. While this doesn't allow
+capture of early kernel panics, it does capture most of the boot
+process.
+
+It takes a string configuration parameter "netconsole" in the
+following format:
+
+ netconsole=[src-port]@[src-ip]/[<dev>],[tgt-port]@<tgt-ip>/[tgt-macaddr]
+
+   where
+        src-port      source for UDP packets (defaults to 6665)
+        src-ip        source IP to use (interface address)
+        dev           network interface (eth0)
+        tgt-port      port for logging agent (6666)
+        tgt-ip        IP address for logging agent
+        tgt-macaddr   ethernet MAC address for logging agent (broadcast)
+
+Examples:
+
+ linux netconsole=4444@10.0.0.1/eth1,9353@10.0.0.2/12:34:56:78:9a:bc
+
+  or
+
+ insmod netconsole netconsole=@/,@10.0.0.2/
+
+Built-in netconsole starts immediately after the TCP stack is
+initialized and attempts to bring up the supplied dev at the supplied
+address.
+
+The remote host can run either 'netcat -u -l -p <port>' or syslogd.
+
+WARNING: the default target ethernet setting uses the broadcast
+ethernet address to send packets, which can cause increased load on
+other systems on the same ethernet segment.
+
+NOTE: the network device (eth1 in the above case) can run any kind
+of other network traffic, netconsole is not intrusive. Netconsole
+might cause slight delays in other traffic if the volume of kernel
+messages is high, but should have no other impact.
+
+Netconsole was designed to be as instantaneous as possible, to
+enable the logging of even the most critical kernel bugs. It works
+from IRQ contexts as well, and does not enable interrupts while
+sending packets. Due to these unique needs, configuration can not
+be more automatic, and some fundamental limitations will remain:
+only IP networks, UDP packets and ethernet devices are supported.