diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 44 |
1 files changed, 31 insertions, 13 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index 614d0382e2c..a8ba119a4d5 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -49,6 +49,7 @@ parameter is applicable: EDD BIOS Enhanced Disk Drive Services (EDD) is enabled EFI EFI Partitioning (GPT) is enabled EIDE EIDE/ATAPI support is enabled. + EVM Extended Verification Module FB The frame buffer device is enabled. FTRACE Function tracing enabled. GCOV GCOV profiling is enabled. @@ -163,7 +164,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. rsdt -- prefer RSDT over (default) XSDT copy_dsdt -- copy DSDT to memory - See also Documentation/power/pm.txt, pci=noacpi + See also Documentation/power/runtime_pm.txt, pci=noacpi acpi_rsdp= [ACPI,EFI,KEXEC] Pass the RSDP address to the kernel, mostly used @@ -319,7 +320,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. amijoy.map= [HW,JOY] Amiga joystick support Map of devices attached to JOY0DAT and JOY1DAT Format: <a>,<b> - See also Documentation/kernel/input/joystick.txt + See also Documentation/input/joystick.txt analog.map= [HW,JOY] Analog joystick and gamepad support Specifies type or capabilities of an analog joystick @@ -408,7 +409,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. bttv.radio= Most important insmod options are available as kernel args too. bttv.pll= See Documentation/video4linux/bttv/Insmod-options - bttv.tuner= and Documentation/video4linux/bttv/CARDLIST + bttv.tuner= bulk_remove=off [PPC] This parameter disables the use of the pSeries firmware feature for flushing multiple hpte entries @@ -724,7 +725,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. elevator= [IOSCHED] Format: {"cfq" | "deadline" | "noop"} - See Documentation/block/as-iosched.txt and + See Documentation/block/cfq-iosched.txt and Documentation/block/deadline-iosched.txt for details. elfcorehdr= [IA-64,PPC,SH,X86] @@ -760,12 +761,17 @@ bytes respectively. Such letter suffixes can also be entirely omitted. This option is obsoleted by the "netdev=" option, which has equivalent usage. See its documentation for details. + evm= [EVM] + Format: { "fix" } + Permit 'security.evm' to be updated regardless of + current integrity status. + failslab= fail_page_alloc= fail_make_request=[KNL] General fault injection mechanism. Format: <interval>,<probability>,<space>,<times> - See also /Documentation/fault-injection/. + See also Documentation/fault-injection/. floppy= [HW] See Documentation/blockdev/floppy.txt. @@ -1014,10 +1020,11 @@ bytes respectively. Such letter suffixes can also be entirely omitted. has the capability. With this option, super page will not be supported. intremap= [X86-64, Intel-IOMMU] - Format: { on (default) | off | nosid } on enable Interrupt Remapping (default) off disable Interrupt Remapping nosid disable Source ID checking + no_x2apic_optout + BIOS x2APIC opt-out request will be ignored inttest= [IA-64] @@ -2086,9 +2093,12 @@ bytes respectively. Such letter suffixes can also be entirely omitted. Override pmtimer IOPort with a hex value. e.g. pmtmr=0x508 - pnp.debug [PNP] - Enable PNP debug messages. This depends on the - CONFIG_PNP_DEBUG_MESSAGES option. + pnp.debug=1 [PNP] + Enable PNP debug messages (depends on the + CONFIG_PNP_DEBUG_MESSAGES option). Change at run-time + via /sys/module/pnp/parameters/debug. We always show + current resource usage; turning this on also shows + possible settings and some assignment information. pnpacpi= [ACPI] { off } @@ -2237,6 +2247,13 @@ bytes respectively. Such letter suffixes can also be entirely omitted. in <PAGE_SIZE> units (needed only for swap files). See Documentation/power/swsusp-and-swap-files.txt + resumedelay= [HIBERNATION] Delay (in seconds) to pause before attempting to + read the resume files + + resumewait [HIBERNATION] Wait (indefinitely) for resume device to show up. + Useful for devices that are detected asynchronously + (e.g. USB and MMC devices). + hibernate= [HIBERNATION] noresume Don't check if there's a hibernation image present during boot. @@ -2372,7 +2389,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. Format: <integer> sonypi.*= [HW] Sony Programmable I/O Control Device driver - See Documentation/sonypi.txt + See Documentation/laptops/sonypi.txt specialix= [HW,SERIAL] Specialix multi-serial port adapter See Documentation/serial/specialix.txt. @@ -2703,10 +2720,11 @@ bytes respectively. Such letter suffixes can also be entirely omitted. functions are at fixed addresses, they make nice targets for exploits that can control RIP. - emulate [default] Vsyscalls turn into traps and are - emulated reasonably safely. + emulate Vsyscalls turn into traps and are emulated + reasonably safely. - native Vsyscalls are native syscall instructions. + native [default] Vsyscalls are native syscall + instructions. This is a little bit faster than trapping and makes a few dynamic recompilers work better than they would in emulation mode. |