aboutsummaryrefslogtreecommitdiff
path: root/Documentation/arm
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/arm')
-rw-r--r--Documentation/arm/Booting5
-rw-r--r--Documentation/arm/SH-Mobile/zboot-rom-sdhi.txt42
2 files changed, 47 insertions, 0 deletions
diff --git a/Documentation/arm/Booting b/Documentation/arm/Booting
index 4e686a2ed91..a341d87d276 100644
--- a/Documentation/arm/Booting
+++ b/Documentation/arm/Booting
@@ -164,3 +164,8 @@ In either case, the following conditions must be met:
- The boot loader is expected to call the kernel image by jumping
directly to the first instruction of the kernel image.
+ On CPUs supporting the ARM instruction set, the entry must be
+ made in ARM state, even for a Thumb-2 kernel.
+
+ On CPUs supporting only the Thumb instruction set such as
+ Cortex-M class CPUs, the entry must be made in Thumb state.
diff --git a/Documentation/arm/SH-Mobile/zboot-rom-sdhi.txt b/Documentation/arm/SH-Mobile/zboot-rom-sdhi.txt
new file mode 100644
index 00000000000..441959846e1
--- /dev/null
+++ b/Documentation/arm/SH-Mobile/zboot-rom-sdhi.txt
@@ -0,0 +1,42 @@
+ROM-able zImage boot from eSD
+-----------------------------
+
+An ROM-able zImage compiled with ZBOOT_ROM_SDHI may be written to eSD and
+SuperH Mobile ARM will to boot directly from the SDHI hardware block.
+
+This is achieved by the mask ROM loading the first portion of the image into
+MERAM and then jumping to it. This portion contains loader code which
+copies the entire image to SDRAM and jumps to it. From there the zImage
+boot code proceeds as normal, uncompressing the image into its final
+location and then jumping to it.
+
+This code has been tested on an mackerel board using the developer 1A eSD
+boot mode which is configured using the following jumper settings.
+
+ 8 7 6 5 4 3 2 1
+ x|x|x|x| |x|x|
+S4 -+-+-+-+-+-+-+-
+ | | | |x| | |x on
+
+The eSD card needs to be present in SDHI slot 1 (CN7).
+As such S1 and S33 also need to be configured as per
+the notes in arch/arm/mach-shmobile/board-mackerel.c.
+
+A partial zImage must be written to physical partition #1 (boot)
+of the eSD at sector 0 in vrl4 format. A utility vrl4 is supplied to
+accomplish this.
+
+e.g.
+ vrl4 < zImage | dd of=/dev/sdX bs=512 count=17
+
+A full copy of _the same_ zImage should be written to physical partition #1
+(boot) of the eSD at sector 0. This should _not_ be in vrl4 format.
+
+ vrl4 < zImage | dd of=/dev/sdX bs=512
+
+Note: The commands above assume that the physical partition has been
+switched. No such facility currently exists in the Linux Kernel.
+
+Physical partitions are described in the eSD specification. At the time of
+writing they are not the same as partitions that are typically configured
+using fdisk and visible through /proc/partitions