diff options
Diffstat (limited to 'Documentation/DocBook/libata.tmpl')
| -rw-r--r-- | Documentation/DocBook/libata.tmpl | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/DocBook/libata.tmpl b/Documentation/DocBook/libata.tmpl index 8c5411cfeaf..cdd1bb9aac0 100644 --- a/Documentation/DocBook/libata.tmpl +++ b/Documentation/DocBook/libata.tmpl @@ -1032,7 +1032,7 @@ and other resources, etc. <listitem> <para> This is indicated by ICRC bit in the ERROR register and - means that corruption occurred during data transfer. Upto + means that corruption occurred during data transfer. Up to ATA/ATAPI-7, the standard specifies that this bit is only applicable to UDMA transfers but ATA/ATAPI-8 draft revision 1f says that the bit may be applicable to multiword DMA and @@ -1045,10 +1045,10 @@ and other resources, etc. <term>ABRT error during data transfer or on completion</term> <listitem> <para> - Upto ATA/ATAPI-7, the standard specifies that ABRT could be + Up to ATA/ATAPI-7, the standard specifies that ABRT could be set on ICRC errors and on cases where a device is not able to complete a command. Combined with the fact that MWDMA - and PIO transfer errors aren't allowed to use ICRC bit upto + and PIO transfer errors aren't allowed to use ICRC bit up to ATA/ATAPI-7, it seems to imply that ABRT bit alone could indicate tranfer errors. </para> @@ -1122,7 +1122,7 @@ and other resources, etc. <para> Depending on commands, not all STATUS/ERROR bits are applicable. These non-applicable bits are marked with - "na" in the output descriptions but upto ATA/ATAPI-7 + "na" in the output descriptions but up to ATA/ATAPI-7 no definition of "na" can be found. However, ATA/ATAPI-8 draft revision 1f describes "N/A" as follows. @@ -1507,7 +1507,7 @@ and other resources, etc. <listitem> <para> - CHS set up with INITIALIZE DEVICE PARAMETERS (seldomly used) + CHS set up with INITIALIZE DEVICE PARAMETERS (seldom used) </para> </listitem> |