diff options
| -rw-r--r-- | drivers/net/arm/at91_ether.c | 32 |
1 files changed, 19 insertions, 13 deletions
diff --git a/drivers/net/arm/at91_ether.c b/drivers/net/arm/at91_ether.c index 442938d5038..7f4bc8ae546 100644 --- a/drivers/net/arm/at91_ether.c +++ b/drivers/net/arm/at91_ether.c @@ -577,7 +577,7 @@ static void at91ether_sethashtable(struct net_device *dev) /* * Enable/Disable promiscuous and multicast modes. */ -static void at91ether_set_rx_mode(struct net_device *dev) +static void at91ether_set_multicast_list(struct net_device *dev) { unsigned long cfg; @@ -808,7 +808,7 @@ static int at91ether_close(struct net_device *dev) /* * Transmit packet. */ -static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) +static int at91ether_start_xmit(struct sk_buff *skb, struct net_device *dev) { struct at91_private *lp = netdev_priv(dev); @@ -828,7 +828,7 @@ static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) dev->trans_start = jiffies; } else { - printk(KERN_ERR "at91_ether.c: at91ether_tx() called, but device is busy!\n"); + printk(KERN_ERR "at91_ether.c: at91ether_start_xmit() called, but device is busy!\n"); return 1; /* if we return anything but zero, dev.c:1055 calls kfree_skb(skb) on this skb, he also reports -ENETDOWN and printk's, so either we free and return(0) or don't free and return 1 */ @@ -965,6 +965,21 @@ static void at91ether_poll_controller(struct net_device *dev) } #endif +static const struct net_device_ops at91ether_netdev_ops = { + .ndo_open = at91ether_open, + .ndo_stop = at91ether_close, + .ndo_start_xmit = at91ether_start_xmit, + .ndo_get_stats = at91ether_stats, + .ndo_set_multicast_list = at91ether_set_multicast_list, + .ndo_set_mac_address = set_mac_address, + .ndo_do_ioctl = at91ether_ioctl, + .ndo_validate_addr = eth_validate_addr, + .ndo_change_mtu = eth_change_mtu, +#ifdef CONFIG_NET_POLL_CONTROLLER + .ndo_poll_controller = at91ether_poll_controller, +#endif +}; + /* * Initialize the ethernet interface */ @@ -1005,17 +1020,8 @@ static int __init at91ether_setup(unsigned long phy_type, unsigned short phy_add spin_lock_init(&lp->lock); ether_setup(dev); - dev->open = at91ether_open; - dev->stop = at91ether_close; - dev->hard_start_xmit = at91ether_tx; - dev->get_stats = at91ether_stats; - dev->set_multicast_list = at91ether_set_rx_mode; - dev->set_mac_address = set_mac_address; + dev->netdev_ops = &at91ether_netdev_ops; dev->ethtool_ops = &at91ether_ethtool_ops; - dev->do_ioctl = at91ether_ioctl; -#ifdef CONFIG_NET_POLL_CONTROLLER - dev->poll_controller = at91ether_poll_controller; -#endif SET_NETDEV_DEV(dev, &pdev->dev); |