Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-next-2.6 into for-davem

Conflicts:
	drivers/net/wireless/libertas_tf/cmd.c
	drivers/net/wireless/libertas_tf/main.c

2 files changed, 15 insertions, 10 deletions

diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index 5a4efe54cff..7d10c0182f5 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -511,6 +511,7 @@ struct mpath_info {
  * @basic_rates: basic rates in IEEE 802.11 format
  *	(or NULL for no change)
  * @basic_rates_len: number of basic rates
+ * @ap_isolate: do not forward packets between connected stations
  */
 struct bss_parameters {
 	int use_cts_prot;
@@ -518,6 +519,7 @@ struct bss_parameters {
 	int use_short_slot_time;
 	u8 *basic_rates;
 	u8 basic_rates_len;
+	int ap_isolate;
 };
 
 struct mesh_config {
@@ -1018,6 +1020,8 @@ struct cfg80211_pmksa {
  *	RSN IE. It allows for faster roaming between WPA2 BSSIDs.
  * @del_pmksa: Delete a cached PMKID.
  * @flush_pmksa: Flush all cached PMKIDs.
+ * @set_power_mgmt: Configure WLAN power management. A timeout value of -1
+ *	allows the driver to adjust the dynamic ps timeout value.
  * @set_cqm_rssi_config: Configure connection quality monitor RSSI threshold.
  *
  */
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 78908b516f4..54aa16b98b7 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -145,6 +145,7 @@ struct ieee80211_low_level_stats {
  * @BSS_CHANGED_BEACON_ENABLED: Beaconing should be
  *	enabled/disabled (beaconing modes)
  * @BSS_CHANGED_CQM: Connection quality monitor config changed
+ * @BSS_CHANGED_IBSS: IBSS join status changed
  */
 enum ieee80211_bss_change {
 	BSS_CHANGED_ASSOC		= 1<<0,
@@ -158,6 +159,7 @@ enum ieee80211_bss_change {
 	BSS_CHANGED_BEACON		= 1<<8,
 	BSS_CHANGED_BEACON_ENABLED	= 1<<9,
 	BSS_CHANGED_CQM			= 1<<10,
+	BSS_CHANGED_IBSS		= 1<<11,
 };
 
 /**
@@ -167,6 +169,8 @@ enum ieee80211_bss_change {
  * to that BSS) that can change during the lifetime of the BSS.
  *
  * @assoc: association status
+ * @ibss_joined: indicates whether this station is part of an IBSS
+ *	or not
  * @aid: association ID number, valid only when @assoc is true
  * @use_cts_prot: use CTS protection
  * @use_short_preamble: use 802.11b short preamble;
@@ -194,7 +198,7 @@ enum ieee80211_bss_change {
 struct ieee80211_bss_conf {
 	const u8 *bssid;
 	/* association related data */
-	bool assoc;
+	bool assoc, ibss_joined;
 	u16 aid;
 	/* erp related data */
 	bool use_cts_prot;
@@ -556,7 +560,6 @@ enum mac80211_rx_flags {
  * @signal: signal strength when receiving this frame, either in dBm, in dB or
  *	unspecified depending on the hardware capabilities flags
  *	@IEEE80211_HW_SIGNAL_*
- * @noise: noise when receiving this frame, in dBm (DEPRECATED).
  * @antenna: antenna used
  * @rate_idx: index of data rate into band's supported rates or MCS index if
  *	HT rates are use (RX_FLAG_HT)
@@ -567,7 +570,6 @@ struct ieee80211_rx_status {
 	enum ieee80211_band band;
 	int freq;
 	int signal;
-	int noise __deprecated;
 	int antenna;
 	int rate_idx;
 	int flag;
@@ -668,6 +670,9 @@ enum ieee80211_smps_mode {
  * @dynamic_ps_timeout: The dynamic powersave timeout (in ms), see the
  *	powersave documentation below. This variable is valid only when
  *	the CONF_PS flag is set.
+ * @dynamic_ps_forced_timeout: The dynamic powersave timeout (in ms) configured
+ *	by cfg80211 (essentially, wext) If set, this value overrules the value
+ *	chosen by mac80211 based on ps qos network latency.
  *
  * @power_level: requested transmit power (in dBm)
  *
@@ -687,7 +692,7 @@ enum ieee80211_smps_mode {
  */
 struct ieee80211_conf {
 	u32 flags;
-	int power_level, dynamic_ps_timeout;
+	int power_level, dynamic_ps_timeout, dynamic_ps_forced_timeout;
 	int max_sleep_period;
 
 	u16 listen_interval;
@@ -927,10 +932,6 @@ enum ieee80211_tkip_key_type {
  *	one milliwatt. This is the preferred method since it is standardized
  *	between different devices. @max_signal does not need to be set.
  *
- * @IEEE80211_HW_NOISE_DBM:
- *	Hardware can provide noise (radio interference) values in units dBm,
- *      decibel difference from one milliwatt.
- *
  * @IEEE80211_HW_SPECTRUM_MGMT:
  * 	Hardware supports spectrum management defined in 802.11h
  * 	Measurement, Channel Switch, Quieting, TPC
@@ -994,7 +995,7 @@ enum ieee80211_hw_flags {
 	IEEE80211_HW_2GHZ_SHORT_PREAMBLE_INCAPABLE	= 1<<4,
 	IEEE80211_HW_SIGNAL_UNSPEC			= 1<<5,
 	IEEE80211_HW_SIGNAL_DBM				= 1<<6,
-	IEEE80211_HW_NOISE_DBM				= 1<<7,
+	/* use this hole */
 	IEEE80211_HW_SPECTRUM_MGMT			= 1<<8,
 	IEEE80211_HW_AMPDU_AGGREGATION			= 1<<9,
 	IEEE80211_HW_SUPPORTS_PS			= 1<<10,
@@ -1654,7 +1655,7 @@ struct ieee80211_ops {
 				struct ieee80211_key_conf *conf,
 				struct ieee80211_sta *sta,
 				u32 iv32, u16 *phase1key);
-	int (*hw_scan)(struct ieee80211_hw *hw,
+	int (*hw_scan)(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
 		       struct cfg80211_scan_request *req);
 	void (*sw_scan_start)(struct ieee80211_hw *hw);
 	void (*sw_scan_complete)(struct ieee80211_hw *hw);