serial/imx: get rid of the uses of cpu_is_mx1()

The patch removes all the uses of cpu_is_mx1().  Instead, it uses
the .id_table of platform_driver to distinguish the uart device type,
IMX1_UART and IMX21_UART.  The IMX21_UART type runs on all i.mx
except i.mx1.

A couple of !cpu_is_mx1 logic gets turned into is_imx21_uart,
as the codes wrapped there are really IMX21 type uart specific.

It also removes macro MX1_UCR3_REF25 and MX1_UCR3_REF30 which are
not used anywhere.

Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Cc: Sascha Hauer <s.hauer@pengutronix.de>
Cc: Alan Cox <alan@linux.intel.com>
Cc: Greg Kroah-Hartman <gregkh@suse.de>
Acked-by: Grant Likely <grant.likely@secretlab.ca>

1 files changed, 69 insertions, 16 deletions

diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index 22fe801cce3..2d5eac20c5c 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -48,7 +48,6 @@
 
 #include <asm/io.h>
 #include <asm/irq.h>
-#include <mach/hardware.h>
 #include <mach/imx-uart.h>
 
 /* Register definitions */
@@ -66,8 +65,9 @@
 #define UBIR  0xa4 /* BRM Incremental Register */
 #define UBMR  0xa8 /* BRM Modulator Register */
 #define UBRC  0xac /* Baud Rate Count Register */
-#define MX2_ONEMS 0xb0 /* One Millisecond register */
-#define UTS (cpu_is_mx1() ? 0xd0 : 0xb4) /* UART Test Register */
+#define IMX21_ONEMS 0xb0 /* One Millisecond register */
+#define IMX1_UTS 0xd0 /* UART Test Register on i.mx1 */
+#define IMX21_UTS 0xb4 /* UART Test Register on all other i.mx*/
 
 /* UART Control Register Bit Fields.*/
 #define  URXD_CHARRDY    (1<<15)
@@ -87,7 +87,7 @@
 #define  UCR1_RTSDEN     (1<<5)	 /* RTS delta interrupt enable */
 #define  UCR1_SNDBRK     (1<<4)	 /* Send break */
 #define  UCR1_TDMAEN     (1<<3)	 /* Transmitter ready DMA enable */
-#define  MX1_UCR1_UARTCLKEN  (1<<2)	 /* UART clock enabled, mx1 only */
+#define  IMX1_UCR1_UARTCLKEN  (1<<2)  /* UART clock enabled, i.mx1 only */
 #define  UCR1_DOZE       (1<<1)	 /* Doze */
 #define  UCR1_UARTEN     (1<<0)	 /* UART enabled */
 #define  UCR2_ESCI     	 (1<<15) /* Escape seq interrupt enable */
@@ -113,9 +113,7 @@
 #define  UCR3_RXDSEN	 (1<<6)  /* Receive status interrupt enable */
 #define  UCR3_AIRINTEN   (1<<5)  /* Async IR wake interrupt enable */
 #define  UCR3_AWAKEN	 (1<<4)  /* Async wake interrupt enable */
-#define  MX1_UCR3_REF25 	 (1<<3)  /* Ref freq 25 MHz, only on mx1 */
-#define  MX1_UCR3_REF30 	 (1<<2)  /* Ref Freq 30 MHz, only on mx1 */
-#define  MX2_UCR3_RXDMUXSEL	 (1<<2)  /* RXD Muxed Input Select, on mx2/mx3 */
+#define  IMX21_UCR3_RXDMUXSEL	 (1<<2)  /* RXD Muxed Input Select */
 #define  UCR3_INVT  	 (1<<1)  /* Inverted Infrared transmission */
 #define  UCR3_BPEN  	 (1<<0)  /* Preset registers enable */
 #define  UCR4_CTSTL_SHF  10      /* CTS trigger level shift */
@@ -181,6 +179,18 @@
 
 #define UART_NR 8
 
+/* i.mx21 type uart runs on all i.mx except i.mx1 */
+enum imx_uart_type {
+	IMX1_UART,
+	IMX21_UART,
+};
+
+/* device type dependent stuff */
+struct imx_uart_data {
+	unsigned uts_reg;
+	enum imx_uart_type devtype;
+};
+
 struct imx_port {
 	struct uart_port	port;
 	struct timer_list	timer;
@@ -192,6 +202,7 @@ struct imx_port {
 	unsigned int		irda_inv_tx:1;
 	unsigned short		trcv_delay; /* transceiver delay */
 	struct clk		*clk;
+	struct imx_uart_data	*devdata;
 };
 
 #ifdef CONFIG_IRDA
@@ -200,6 +211,45 @@ struct imx_port {
 #define USE_IRDA(sport)	(0)
 #endif
 
+static struct imx_uart_data imx_uart_devdata[] = {
+	[IMX1_UART] = {
+		.uts_reg = IMX1_UTS,
+		.devtype = IMX1_UART,
+	},
+	[IMX21_UART] = {
+		.uts_reg = IMX21_UTS,
+		.devtype = IMX21_UART,
+	},
+};
+
+static struct platform_device_id imx_uart_devtype[] = {
+	{
+		.name = "imx1-uart",
+		.driver_data = (kernel_ulong_t) &imx_uart_devdata[IMX1_UART],
+	}, {
+		.name = "imx21-uart",
+		.driver_data = (kernel_ulong_t) &imx_uart_devdata[IMX21_UART],
+	}, {
+		/* sentinel */
+	}
+};
+MODULE_DEVICE_TABLE(platform, imx_uart_devtype);
+
+static inline unsigned uts_reg(struct imx_port *sport)
+{
+	return sport->devdata->uts_reg;
+}
+
+static inline int is_imx1_uart(struct imx_port *sport)
+{
+	return sport->devdata->devtype == IMX1_UART;
+}
+
+static inline int is_imx21_uart(struct imx_port *sport)
+{
+	return sport->devdata->devtype == IMX21_UART;
+}
+
 /*
  * Handle any change of modem status signal since we were last called.
  */
@@ -326,7 +376,8 @@ static inline void imx_transmit_buffer(struct imx_port *sport)
 	struct circ_buf *xmit = &sport->port.state->xmit;
 
 	while (!uart_circ_empty(xmit) &&
-			!(readl(sport->port.membase + UTS) & UTS_TXFULL)) {
+			!(readl(sport->port.membase + uts_reg(sport))
+				& UTS_TXFULL)) {
 		/* send xmit->buf[xmit->tail]
 		 * out the port here */
 		writel(xmit->buf[xmit->tail], sport->port.membase + URTX0);
@@ -373,7 +424,7 @@ static void imx_start_tx(struct uart_port *port)
 		writel(temp, sport->port.membase + UCR4);
 	}
 
-	if (readl(sport->port.membase + UTS) & UTS_TXEMPTY)
+	if (readl(sport->port.membase + uts_reg(sport)) & UTS_TXEMPTY)
 		imx_transmit_buffer(sport);
 }
 
@@ -689,9 +740,9 @@ static int imx_startup(struct uart_port *port)
 		}
 	}
 
-	if (!cpu_is_mx1()) {
+	if (is_imx21_uart(sport)) {
 		temp = readl(sport->port.membase + UCR3);
-		temp |= MX2_UCR3_RXDMUXSEL;
+		temp |= IMX21_UCR3_RXDMUXSEL;
 		writel(temp, sport->port.membase + UCR3);
 	}
 
@@ -923,9 +974,9 @@ imx_set_termios(struct uart_port *port, struct ktermios *termios,
 	writel(num, sport->port.membase + UBIR);
 	writel(denom, sport->port.membase + UBMR);
 
-	if (!cpu_is_mx1())
+	if (is_imx21_uart(sport))
 		writel(sport->port.uartclk / div / 1000,
-				sport->port.membase + MX2_ONEMS);
+				sport->port.membase + IMX21_ONEMS);
 
 	writel(old_ucr1, sport->port.membase + UCR1);
 
@@ -1041,7 +1092,7 @@ static void imx_console_putchar(struct uart_port *port, int ch)
 {
 	struct imx_port *sport = (struct imx_port *)port;
 
-	while (readl(sport->port.membase + UTS) & UTS_TXFULL)
+	while (readl(sport->port.membase + uts_reg(sport)) & UTS_TXFULL)
 		barrier();
 
 	writel(ch, sport->port.membase + URTX0);
@@ -1062,8 +1113,8 @@ imx_console_write(struct console *co, const char *s, unsigned int count)
 	ucr1 = old_ucr1 = readl(sport->port.membase + UCR1);
 	old_ucr2 = readl(sport->port.membase + UCR2);
 
-	if (cpu_is_mx1())
-		ucr1 |= MX1_UCR1_UARTCLKEN;
+	if (is_imx1_uart(sport))
+		ucr1 |= IMX1_UCR1_UARTCLKEN;
 	ucr1 |= UCR1_UARTEN;
 	ucr1 &= ~(UCR1_TXMPTYEN | UCR1_RRDYEN | UCR1_RTSDEN);
 
@@ -1262,6 +1313,7 @@ static int serial_imx_probe(struct platform_device *pdev)
 	init_timer(&sport->timer);
 	sport->timer.function = imx_timeout;
 	sport->timer.data     = (unsigned long)sport;
+	sport->devdata = (struct imx_uart_data	*) pdev->id_entry->driver_data;
 
 	sport->clk = clk_get(&pdev->dev, "uart");
 	if (IS_ERR(sport->clk)) {
@@ -1340,6 +1392,7 @@ static struct platform_driver serial_imx_driver = {
 
 	.suspend	= serial_imx_suspend,
 	.resume		= serial_imx_resume,
+	.id_table	= imx_uart_devtype,
 	.driver		= {
 		.name	= "imx-uart",
 		.owner	= THIS_MODULE,