xircom: convert devices to new API

Convert to net_device_ops and internal net_device_stats

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 19 insertions, 24 deletions

diff --git a/drivers/net/tulip/xircom_cb.c b/drivers/net/tulip/xircom_cb.c
index 13c8703ecb9..c2ca9f40e40 100644
--- a/drivers/net/tulip/xircom_cb.c
+++ b/drivers/net/tulip/xircom_cb.c
@@ -104,10 +104,8 @@ struct xircom_private {
 	 */
 	spinlock_t lock;
 
-
 	struct pci_dev *pdev;
 	struct net_device *dev;
-	struct net_device_stats stats;
 };
 
 
@@ -119,7 +117,6 @@ static int xircom_start_xmit(struct sk_buff *skb, struct net_device *dev);
 static int xircom_open(struct net_device *dev);
 static int xircom_close(struct net_device *dev);
 static void xircom_up(struct xircom_private *card);
-static struct net_device_stats *xircom_get_stats(struct net_device *dev);
 #ifdef CONFIG_NET_POLL_CONTROLLER
 static void xircom_poll_controller(struct net_device *dev);
 #endif
@@ -194,6 +191,18 @@ static const struct ethtool_ops netdev_ethtool_ops = {
 	.get_drvinfo		= netdev_get_drvinfo,
 };
 
+static const struct net_device_ops netdev_ops = {
+	.ndo_open		= xircom_open,
+	.ndo_stop		= xircom_close,
+	.ndo_start_xmit		= xircom_start_xmit,
+	.ndo_change_mtu		= eth_change_mtu,
+	.ndo_set_mac_address	= eth_mac_addr,
+	.ndo_validate_addr	= eth_validate_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+	.ndo_poll_controller	= xircom_poll_controller,
+#endif
+};
+
 /* xircom_probe is the code that gets called on device insertion.
    it sets up the hardware and registers the device to the networklayer.
 
@@ -266,13 +275,7 @@ static int __devinit xircom_probe(struct pci_dev *pdev, const struct pci_device_
 	read_mac_address(private);
 	setup_descriptors(private);
 
-	dev->open = &xircom_open;
-	dev->hard_start_xmit = &xircom_start_xmit;
-	dev->stop = &xircom_close;
-	dev->get_stats = &xircom_get_stats;
-#ifdef CONFIG_NET_POLL_CONTROLLER
-	dev->poll_controller = &xircom_poll_controller;
-#endif
+	dev->netdev_ops = &netdev_ops;
 	SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops);
 	pci_set_drvdata(pdev, dev);
 
@@ -497,14 +500,6 @@ static int xircom_close(struct net_device *dev)
 }
 
 
-
-static struct net_device_stats *xircom_get_stats(struct net_device *dev)
-{
-        struct xircom_private *card = netdev_priv(dev);
-        return &card->stats;
-}
-
-
 #ifdef CONFIG_NET_POLL_CONTROLLER
 static void xircom_poll_controller(struct net_device *dev)
 {
@@ -1193,7 +1188,7 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri
 
 			skb = dev_alloc_skb(pkt_len + 2);
 			if (skb == NULL) {
-				card->stats.rx_dropped++;
+				dev->stats.rx_dropped++;
 				goto out;
 			}
 			skb_reserve(skb, 2);
@@ -1201,8 +1196,8 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri
 			skb_put(skb, pkt_len);
 			skb->protocol = eth_type_trans(skb, dev);
 			netif_rx(skb);
-			card->stats.rx_packets++;
-			card->stats.rx_bytes += pkt_len;
+			dev->stats.rx_packets++;
+			dev->stats.rx_bytes += pkt_len;
 
 		      out:
 			/* give the buffer back to the card */
@@ -1232,16 +1227,16 @@ static void investigate_write_descriptor(struct net_device *dev, struct xircom_p
 #endif
 		if (status > 0) {	/* bit 31 is 0 when done */
 			if (card->tx_skb[descnr]!=NULL) {
-				card->stats.tx_bytes += card->tx_skb[descnr]->len;
+				dev->stats.tx_bytes += card->tx_skb[descnr]->len;
 				dev_kfree_skb_irq(card->tx_skb[descnr]);
 			}
 			card->tx_skb[descnr] = NULL;
 			/* Bit 8 in the status field is 1 if there was a collision */
 			if (status&(1<<8))
-				card->stats.collisions++;
+				dev->stats.collisions++;
 			card->tx_buffer[4*descnr] = 0; /* descriptor is free again */
 			netif_wake_queue (dev);
-			card->stats.tx_packets++;
+			dev->stats.tx_packets++;
 		}
 
 		leave("investigate_write_descriptor");