[netdrvr] Use dev_printk() when ethernet interface isn't available

For messages prior to register_netdev(), prefer dev_printk() because
that prints out both our driver name and our [PCI | whatever] bus id.

Updates: 8139{cp,too}, b44, bnx2, cassini, {eepro,epic}100, fealnx,
	 hamachi, ne2k-pci, ns83820, pci-skeleton, r8169.

Signed-off-by: Jeff Garzik <jeff@garzik.org>

1 files changed, 22 insertions, 16 deletions

diff --git a/drivers/net/8139cp.c b/drivers/net/8139cp.c
index 1959654cbec..93b7c904bba 100644
--- a/drivers/net/8139cp.c
+++ b/drivers/net/8139cp.c
@@ -1836,9 +1836,11 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
 
 	if (pdev->vendor == PCI_VENDOR_ID_REALTEK &&
 	    pdev->device == PCI_DEVICE_ID_REALTEK_8139 && pci_rev < 0x20) {
-		printk(KERN_ERR PFX "pci dev %s (id %04x:%04x rev %02x) is not an 8139C+ compatible chip\n",
-		       pci_name(pdev), pdev->vendor, pdev->device, pci_rev);
-		printk(KERN_ERR PFX "Try the \"8139too\" driver instead.\n");
+		dev_printk(KERN_ERR, &pdev->dev,
+			   "This (id %04x:%04x rev %02x) is not an 8139C+ compatible chip\n",
+		           pdev->vendor, pdev->device, pci_rev);
+		dev_printk(KERN_ERR, &pdev->dev,
+			   "Try the \"8139too\" driver instead.\n");
 		return -ENODEV;
 	}
 
@@ -1876,14 +1878,14 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
 	pciaddr = pci_resource_start(pdev, 1);
 	if (!pciaddr) {
 		rc = -EIO;
-		printk(KERN_ERR PFX "no MMIO resource for pci dev %s\n",
-		       pci_name(pdev));
+		dev_printk(KERN_ERR, &pdev->dev, "no MMIO resource\n");
 		goto err_out_res;
 	}
 	if (pci_resource_len(pdev, 1) < CP_REGS_SIZE) {
 		rc = -EIO;
-		printk(KERN_ERR PFX "MMIO resource (%llx) too small on pci dev %s\n",
-		       (unsigned long long)pci_resource_len(pdev, 1), pci_name(pdev));
+		dev_printk(KERN_ERR, &pdev->dev,
+			   "MMIO resource (%llx) too small\n",
+		       (unsigned long long)pci_resource_len(pdev, 1));
 		goto err_out_res;
 	}
 
@@ -1897,14 +1899,15 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
 
 		rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
 		if (rc) {
-			printk(KERN_ERR PFX "No usable DMA configuration, "
-			       "aborting.\n");
+			dev_printk(KERN_ERR, &pdev->dev,
+				   "No usable DMA configuration, aborting.\n");
 			goto err_out_res;
 		}
 		rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
 		if (rc) {
-			printk(KERN_ERR PFX "No usable consistent DMA configuration, "
-			       "aborting.\n");
+			dev_printk(KERN_ERR, &pdev->dev,
+				   "No usable consistent DMA configuration, "
+			           "aborting.\n");
 			goto err_out_res;
 		}
 	}
@@ -1915,9 +1918,10 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
 	regs = ioremap(pciaddr, CP_REGS_SIZE);
 	if (!regs) {
 		rc = -EIO;
-		printk(KERN_ERR PFX "Cannot map PCI MMIO (%llx@%llx) on pci dev %s\n",
-			(unsigned long long)pci_resource_len(pdev, 1),
-			(unsigned long long)pciaddr, pci_name(pdev));
+		dev_printk(KERN_ERR, &pdev->dev,
+			   "Cannot map PCI MMIO (%llx@%llx)\n",
+		       (unsigned long long)pci_resource_len(pdev, 1),
+		       (unsigned long long)pciaddr);
 		goto err_out_res;
 	}
 	dev->base_addr = (unsigned long) regs;
@@ -1986,7 +1990,8 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
 	/* enable busmastering and memory-write-invalidate */
 	pci_set_master(pdev);
 
-	if (cp->wol_enabled) cp_set_d3_state (cp);
+	if (cp->wol_enabled)
+		cp_set_d3_state (cp);
 
 	return 0;
 
@@ -2011,7 +2016,8 @@ static void cp_remove_one (struct pci_dev *pdev)
 	BUG_ON(!dev);
 	unregister_netdev(dev);
 	iounmap(cp->regs);
-	if (cp->wol_enabled) pci_set_power_state (pdev, PCI_D0);
+	if (cp->wol_enabled)
+		pci_set_power_state (pdev, PCI_D0);
 	pci_release_regions(pdev);
 	pci_clear_mwi(pdev);
 	pci_disable_device(pdev);