diff options
| author | Matthieu CASTET <matthieu.castet@parrot.com> | 2012-11-05 15:00:44 +0100 |
|---|---|---|
| committer | Artem Bityutskiy <Artem.Bityutskiy@linux.intel.com> | 2012-11-15 19:50:30 +0200 |
| commit | f251b8dfdd0721255ea11751cdc282834e43b74e (patch) | |
| tree | ada4f9467ab39c19d95fb8529e3de21c362f0539 /drivers/mtd | |
| parent | 192afdbfbc5c3346e27b3c3e3be8337495b2a41b (diff) | |
mtd: nand_wait: warn if the nand is busy on exit
This patch allow to detect buggy driver/hardware with
bad RnB (dev_ready) management or when timeout occurs in polling mode.
This works when dev_ready is set or not set.
There are 2 methods to wait for an erase/program command completion:
1. Wait until nand RnB pin goes high (that's what chip->dev_ready usually does)
2. Poll the device: send a status (0x70) command and read status byte in a loop
until bit NAND_STATUS_READY is set
In all cases, you should send a status command after completion, to check if
the operation was successful. And if the operation completed, the status should
have bit NAND_STATUS_READY set.
Signed-off-by: Matthieu CASTET <matthieu.castet@parrot.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Diffstat (limited to 'drivers/mtd')
| -rw-r--r-- | drivers/mtd/nand/nand_base.c | 2 |
1 files changed, 2 insertions, 0 deletions
diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c index 1d5c951ebcb..01505406ca7 100644 --- a/drivers/mtd/nand/nand_base.c +++ b/drivers/mtd/nand/nand_base.c @@ -865,6 +865,8 @@ static int nand_wait(struct mtd_info *mtd, struct nand_chip *chip) led_trigger_event(nand_led_trigger, LED_OFF); status = (int)chip->read_byte(mtd); + /* This can happen if in case of timeout or buggy dev_ready */ + WARN_ON(!(status & NAND_STATUS_READY)); return status; } |