firewire: ohci: enable 1394a enhancements

The OHCI spec says that, if the programPhyEnable bit is set, the driver
is responsible for configuring the IEEE1394a enhancements within the PHY
and the link consistently.  So do this.

Also add a quirk to allow disabling these enhancements; this is needed
for the TSB12LV22 where ack accelerations are buggy (erratum b).

Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

1 files changed, 81 insertions, 2 deletions

diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c
index 525848f71c3..e934713f3fc 100644
--- a/drivers/firewire/ohci.c
+++ b/drivers/firewire/ohci.c
@@ -236,13 +236,15 @@ static char ohci_driver_name[] = KBUILD_MODNAME;
 #define QUIRK_CYCLE_TIMER		1
 #define QUIRK_RESET_PACKET		2
 #define QUIRK_BE_HEADERS		4
+#define QUIRK_NO_1394A			8
 
 /* In case of multiple matches in ohci_quirks[], only the first one is used. */
 static const struct {
 	unsigned short vendor, device, flags;
 } ohci_quirks[] = {
 	{PCI_VENDOR_ID_TI,	PCI_DEVICE_ID_TI_TSB12LV22, QUIRK_CYCLE_TIMER |
-							    QUIRK_RESET_PACKET},
+							    QUIRK_RESET_PACKET |
+							    QUIRK_NO_1394A},
 	{PCI_VENDOR_ID_TI,	PCI_ANY_ID,	QUIRK_RESET_PACKET},
 	{PCI_VENDOR_ID_AL,	PCI_ANY_ID,	QUIRK_CYCLE_TIMER},
 	{PCI_VENDOR_ID_NEC,	PCI_ANY_ID,	QUIRK_CYCLE_TIMER},
@@ -257,6 +259,7 @@ MODULE_PARM_DESC(quirks, "Chip quirks (default = 0"
 	", nonatomic cycle timer = "	__stringify(QUIRK_CYCLE_TIMER)
 	", reset packet generation = "	__stringify(QUIRK_RESET_PACKET)
 	", AR/selfID endianess = "	__stringify(QUIRK_BE_HEADERS)
+	", no 1394a enhancements = "	__stringify(QUIRK_NO_1394A)
 	")");
 
 #ifdef CONFIG_FIREWIRE_OHCI_DEBUG
@@ -504,6 +507,27 @@ static int ohci_update_phy_reg(struct fw_card *card, int addr,
 	return 0;
 }
 
+static int read_paged_phy_reg(struct fw_card *card,
+			      int page, int addr, u32 *value)
+{
+	struct fw_ohci *ohci = fw_ohci(card);
+	u32 reg;
+	int err;
+
+	err = ohci_update_phy_reg(card, 7, PHY_PAGE_SELECT, page << 5);
+	if (err < 0)
+		return err;
+	flush_writes(ohci);
+	msleep(2);
+	reg = reg_read(ohci, OHCI1394_PhyControl);
+	if ((reg & OHCI1394_PhyControl_WritePending) != 0) {
+		fw_error("failed to write phy reg bits\n");
+		return -EBUSY;
+	}
+
+	return read_phy_reg(card, addr, value);
+}
+
 static int ar_context_add_page(struct ar_context *ctx)
 {
 	struct device *dev = ctx->ohci->card.device;
@@ -1511,13 +1535,64 @@ static void copy_config_rom(__be32 *dest, const __be32 *src, size_t length)
 		memset(&dest[length], 0, CONFIG_ROM_SIZE - size);
 }
 
+static int configure_1394a_enhancements(struct fw_ohci *ohci)
+{
+	bool enable_1394a;
+	u32 reg, phy_compliance;
+	int clear, set, offset;
+
+	/* Check if the driver should configure link and PHY. */
+	if (!(reg_read(ohci, OHCI1394_HCControlSet) &
+	      OHCI1394_HCControl_programPhyEnable))
+		return 0;
+
+	/* Paranoia: check whether the PHY supports 1394a, too. */
+	enable_1394a = false;
+	if (read_phy_reg(&ohci->card, 2, &reg) < 0)
+		return -EIO;
+	if ((reg & PHY_EXTENDED_REGISTERS) == PHY_EXTENDED_REGISTERS) {
+		if (read_paged_phy_reg(&ohci->card, 1, 8, &phy_compliance) < 0)
+			return -EIO;
+		if (phy_compliance >= 1)
+			enable_1394a = true;
+	}
+
+	if (ohci->quirks & QUIRK_NO_1394A)
+		enable_1394a = false;
+
+	/* Configure PHY and link consistently. */
+	if (enable_1394a) {
+		clear = 0;
+		set = PHY_ENABLE_ACCEL | PHY_ENABLE_MULTI;
+	} else {
+		clear = PHY_ENABLE_ACCEL | PHY_ENABLE_MULTI;
+		set = 0;
+	}
+	if (ohci_update_phy_reg(&ohci->card, 5, clear, set) < 0)
+		return -EIO;
+	flush_writes(ohci);
+	msleep(2);
+
+	if (enable_1394a)
+		offset = OHCI1394_HCControlSet;
+	else
+		offset = OHCI1394_HCControlClear;
+	reg_write(ohci, offset, OHCI1394_HCControl_aPhyEnhanceEnable);
+
+	/* Clean up: configuration has been taken care of. */
+	reg_write(ohci, OHCI1394_HCControlClear,
+		  OHCI1394_HCControl_programPhyEnable);
+
+	return 0;
+}
+
 static int ohci_enable(struct fw_card *card,
 		       const __be32 *config_rom, size_t length)
 {
 	struct fw_ohci *ohci = fw_ohci(card);
 	struct pci_dev *dev = to_pci_dev(card->device);
 	u32 lps;
-	int i;
+	int i, err;
 
 	if (software_reset(ohci)) {
 		fw_error("Failed to reset ohci card.\n");
@@ -1581,6 +1656,10 @@ static int ohci_enable(struct fw_card *card,
 	if (param_debug & OHCI_PARAM_DEBUG_BUSRESETS)
 		reg_write(ohci, OHCI1394_IntMaskSet, OHCI1394_busReset);
 
+	err = configure_1394a_enhancements(ohci);
+	if (err < 0)
+		return err;
+
 	/* Activate link_on bit and contender bit in our self ID packets.*/
 	if (ohci_update_phy_reg(card, 4, 0,
 				PHY_LINK_ACTIVE | PHY_CONTENDER) < 0)