atm: [suni] add support for setting loopback and framing modes

Signed-off-by: Chas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 27 insertions, 4 deletions

diff --git a/drivers/atm/suni.h b/drivers/atm/suni.h
index efa79bfae75..7e3e656b399 100644
--- a/drivers/atm/suni.h
+++ b/drivers/atm/suni.h
@@ -1,7 +1,8 @@
-/* drivers/atm/suni.h - PMC PM5346 SUNI (PHY) declarations */
+/*
+ * drivers/atm/suni.h - S/UNI PHY driver
+ */
  
 /* Written 1995-2000 by Werner Almesberger, EPFL LRC/ICA */
- 
 
 #ifndef DRIVER_ATM_SUNI_H
 #define DRIVER_ATM_SUNI_H
@@ -39,7 +40,8 @@
 #define SUNI_RLOP_LFM		0x1F	/* RLOP Line FEBE MSB */
 #define SUNI_TLOP_CTRL		0x20	/* TLOP Control */
 #define SUNI_TLOP_DIAG		0x21	/* TLOP Diagnostic */
-			     /* 0x22-0x2F reserved */
+			     /* 0x22-0x27 reserved */
+#define SUNI_SSTB_CTRL		0x28
 #define SUNI_RPOP_SC		0x30	/* RPOP Status/Control */
 #define SUNI_RPOP_IS		0x31	/* RPOP Interrupt Status */
 			     /* 0x32 reserved */
@@ -52,6 +54,7 @@
 #define SUNI_RPOP_PFM		0x3B	/* RPOP Path FEBE MSB */
 			     /* 0x3C reserved */
 #define SUNI_RPOP_PBC		0x3D	/* RPOP Path BIP-8 Configuration */
+#define SUNI_RPOP_RC		0x3D	/* RPOP Ring Control (PM5355) */
 			     /* 0x3E-0x3F reserved */
 #define SUNI_TPOP_CD		0x40	/* TPOP Control/Diagnostic */
 #define SUNI_TPOP_PC		0x41	/* TPOP Pointer Control */
@@ -82,7 +85,8 @@
 #define SUNI_TACP_TCC		0x65	/* TACP Transmit Cell Counter */
 #define SUNI_TACP_TCCM		0x66	/* TACP Transmit Cell Counter MSB */
 #define SUNI_TACP_CFG		0x67	/* TACP Configuration */
-			     /* 0x68-0x7F reserved */
+#define SUNI_SPTB_CTRL		0x68	/* SPTB Control */
+			     /* 0x69-0x7F reserved */
 #define	SUNI_MT			0x80	/* Master Test */
 			     /* 0x81-0xFF reserved */
 
@@ -94,9 +98,18 @@
 #define SUNI_MRI_ID_SHIFT 	0
 #define SUNI_MRI_TYPE		0x70	/* R, SUNI type (lite is 011) */
 #define SUNI_MRI_TYPE_SHIFT 	4
+#define SUNI_MRI_TYPE_PM5346	0x3	/* S/UNI 155 LITE */
+#define SUNI_MRI_TYPE_PM5347	0x4	/* S/UNI 155 PLUS */
+#define SUNI_MRI_TYPE_PM5350	0x7	/* S/UNI 155 ULTRA */
+#define SUNI_MRI_TYPE_PM5355	0x1	/* S/UNI 622 */
 #define SUNI_MRI_RESET		0x80	/* RW, reset & power down chip
 					   0: normal operation
 					   1: reset & low power */
+
+/* MCM is reg 0x4 */
+#define SUNI_MCM_LLE		0x20	/* line loopback (PM5355) */
+#define SUNI_MCM_DLE		0x10	/* diagnostic loopback (PM5355) */
+
 /* MCT is reg 5 */
 #define SUNI_MCT_LOOPT		0x01	/* RW, timing source, 0: from
 					   TRCLK+/- */
@@ -144,6 +157,12 @@
 /* TLOP_DIAG is reg 0x21 */
 #define SUNI_TLOP_DIAG_DBIP	0x01	/* insert line BIP err (continuously) */
 
+/* SSTB_CTRL is reg 0x28 */
+#define SUNI_SSTB_CTRL_LEN16	0x01	/* path trace message length bit */
+
+/* RPOP_RC is reg 0x3D (PM5355) */
+#define SUNI_RPOP_RC_ENSS	0x40	/* enable size bit */
+
 /* TPOP_DIAG is reg 0x40 */
 #define SUNI_TPOP_DIAG_PAIS	0x01	/* insert STS path alarm ind (cont) */
 #define SUNI_TPOP_DIAG_DB3	0x02	/* insert path BIP err (continuously) */
@@ -191,6 +210,9 @@
 					   pattern */
 #define SUNI_TACP_IUCHP_GFC_SHIFT 4
 
+/* SPTB_CTRL is reg 0x68 */
+#define SUNI_SPTB_CTRL_LEN16	0x01	/* path trace message length */
+
 /* MT is reg 0x80 */
 #define SUNI_MT_HIZIO		0x01	/* RW, all but data bus & MP interface
 					   tri-state */
@@ -208,6 +230,7 @@
 struct suni_priv {
 	struct k_sonet_stats sonet_stats;	/* link diagnostics */
 	int loop_mode;				/* loopback mode */
+	int type;				/* phy type */
 	struct atm_dev *dev;			/* device back-pointer */
 	struct suni_priv *next;			/* next SUNI */
 };