x86, reboot: Move the real-mode reboot code to an assembly file

Move the real-mode reboot code out to an assembly file (reboot_32.S)
which is allocated using the common lowmem trampoline allocator.

Signed-off-by: H. Peter Anvin <hpa@linux.intel.com>
LKML-Reference: <4D5DFBE4.7090104@intel.com>
Cc: Stephen Rothwell <sfr@canb.auug.org.au>
Cc: Rafael J. Wysocki <rjw@sisk.pl>
Cc: Matthieu Castet <castet.matthieu@free.fr>

1 files changed, 25 insertions, 95 deletions

diff --git a/arch/x86/kernel/reboot.c b/arch/x86/kernel/reboot.c
index fc7aae1e2bc..10c6619c054 100644
--- a/arch/x86/kernel/reboot.c
+++ b/arch/x86/kernel/reboot.c
@@ -295,68 +295,16 @@ static int __init reboot_init(void)
 }
 core_initcall(reboot_init);
 
-/* The following code and data reboots the machine by switching to real
-   mode and jumping to the BIOS reset entry point, as if the CPU has
-   really been reset.  The previous version asked the keyboard
-   controller to pulse the CPU reset line, which is more thorough, but
-   doesn't work with at least one type of 486 motherboard.  It is easy
-   to stop this code working; hence the copious comments. */
-static const unsigned long long
-real_mode_gdt_entries [3] =
-{
-	0x0000000000000000ULL,	/* Null descriptor */
-	0x00009b000000ffffULL,	/* 16-bit real-mode 64k code at 0x00000000 */
-	0x000093000100ffffULL	/* 16-bit real-mode 64k data at 0x00000100 */
-};
+extern const unsigned char machine_real_restart_asm[];
+extern const u64 machine_real_restart_gdt[3];
 
-static const struct desc_ptr
-real_mode_gdt = { sizeof (real_mode_gdt_entries) - 1, (long)real_mode_gdt_entries },
-real_mode_idt = { 0x3ff, 0 };
-
-/* This is 16-bit protected mode code to disable paging and the cache,
-   switch to real mode and jump to the BIOS reset code.
-
-   The instruction that switches to real mode by writing to CR0 must be
-   followed immediately by a far jump instruction, which set CS to a
-   valid value for real mode, and flushes the prefetch queue to avoid
-   running instructions that have already been decoded in protected
-   mode.
-
-   Clears all the flags except ET, especially PG (paging), PE
-   (protected-mode enable) and TS (task switch for coprocessor state
-   save).  Flushes the TLB after paging has been disabled.  Sets CD and
-   NW, to disable the cache on a 486, and invalidates the cache.  This
-   is more like the state of a 486 after reset.  I don't know if
-   something else should be done for other chips.
-
-   More could be done here to set up the registers as if a CPU reset had
-   occurred; hopefully real BIOSs don't assume much. */
-static const unsigned char real_mode_switch [] =
-{
-	0x66, 0x0f, 0x20, 0xc0,			/*    movl  %cr0,%eax        */
-	0x66, 0x83, 0xe0, 0x11,			/*    andl  $0x00000011,%eax */
-	0x66, 0x0d, 0x00, 0x00, 0x00, 0x60,	/*    orl   $0x60000000,%eax */
-	0x66, 0x0f, 0x22, 0xc0,			/*    movl  %eax,%cr0        */
-	0x66, 0x0f, 0x22, 0xd8,			/*    movl  %eax,%cr3        */
-	0x66, 0x0f, 0x20, 0xc3,			/*    movl  %cr0,%ebx        */
-	0x66, 0x81, 0xe3, 0x00, 0x00, 0x00, 0x60,	/*    andl  $0x60000000,%ebx */
-	0x74, 0x02,				/*    jz    f                */
-	0x0f, 0x09,				/*    wbinvd                 */
-	0x24, 0x10,				/* f: andb  $0x10,al         */
-	0x66, 0x0f, 0x22, 0xc0			/*    movl  %eax,%cr0        */
-};
-static const unsigned char jump_to_bios [] =
+void machine_real_restart(unsigned int type)
 {
-	0xea, 0x00, 0x00, 0xff, 0xff		/*    ljmp  $0xffff,$0x0000  */
-};
+	void *restart_va;
+	unsigned long restart_pa;
+	void (*restart_lowmem)(unsigned int);
+	u64 *lowmem_gdt;
 
-/*
- * Switch to real mode and then execute the code
- * specified by the code and length parameters.
- * We assume that length will aways be less that 100!
- */
-void machine_real_restart(const unsigned char *code, int length)
-{
 	local_irq_disable();
 
 	/* Write zero to CMOS register number 0x0f, which the BIOS POST
@@ -384,41 +332,23 @@ void machine_real_restart(const unsigned char *code, int length)
 	   too. */
 	*((unsigned short *)0x472) = reboot_mode;
 
-	/* For the switch to real mode, copy some code to low memory.  It has
-	   to be in the first 64k because it is running in 16-bit mode, and it
-	   has to have the same physical and virtual address, because it turns
-	   off paging.  Copy it near the end of the first page, out of the way
-	   of BIOS variables. */
-	memcpy((void *)(0x1000 - sizeof(real_mode_switch) - 100),
-		real_mode_switch, sizeof (real_mode_switch));
-	memcpy((void *)(0x1000 - 100), code, length);
-
-	/* Set up the IDT for real mode. */
-	load_idt(&real_mode_idt);
-
-	/* Set up a GDT from which we can load segment descriptors for real
-	   mode.  The GDT is not used in real mode; it is just needed here to
-	   prepare the descriptors. */
-	load_gdt(&real_mode_gdt);
-
-	/* Load the data segment registers, and thus the descriptors ready for
-	   real mode.  The base address of each segment is 0x100, 16 times the
-	   selector value being loaded here.  This is so that the segment
-	   registers don't have to be reloaded after switching to real mode:
-	   the values are consistent for real mode operation already. */
-	__asm__ __volatile__ ("movl $0x0010,%%eax\n"
-				"\tmovl %%eax,%%ds\n"
-				"\tmovl %%eax,%%es\n"
-				"\tmovl %%eax,%%fs\n"
-				"\tmovl %%eax,%%gs\n"
-				"\tmovl %%eax,%%ss" : : : "eax");
-
-	/* Jump to the 16-bit code that we copied earlier.  It disables paging
-	   and the cache, switches to real mode, and jumps to the BIOS reset
-	   entry point. */
-	__asm__ __volatile__ ("ljmp $0x0008,%0"
-				:
-				: "i" ((void *)(0x1000 - sizeof (real_mode_switch) - 100)));
+	/* Patch the GDT in the low memory trampoline */
+	lowmem_gdt = TRAMPOLINE_SYM(machine_real_restart_gdt);
+
+	restart_va = TRAMPOLINE_SYM(machine_real_restart_asm);
+	restart_pa = virt_to_phys(restart_va);
+	restart_lowmem = (void (*)(unsigned int))restart_pa;
+
+	/* GDT[0]: GDT self-pointer */
+	lowmem_gdt[0] =
+		(u64)(sizeof(machine_real_restart_gdt) - 1) +
+		((u64)virt_to_phys(lowmem_gdt) << 16);
+	/* GDT[1]: 64K real mode code segment */
+	lowmem_gdt[1] =
+		GDT_ENTRY(0x009b, restart_pa, 0xffff);
+
+	/* Jump to the identity-mapped low memory code */
+	restart_lowmem(type);
 }
 #ifdef CONFIG_APM_MODULE
 EXPORT_SYMBOL(machine_real_restart);
@@ -573,7 +503,7 @@ static void native_machine_emergency_restart(void)
 
 #ifdef CONFIG_X86_32
 		case BOOT_BIOS:
-			machine_real_restart(jump_to_bios, sizeof(jump_to_bios));
+			machine_real_restart(MRR_BIOS);
 
 			reboot_type = BOOT_KBD;
 			break;