linux/include/acpi, branch v2.6.34.8

ACPI / ACPICA: Avoid writing full enable masks to GPE registers

2010-08-02T17:30:20Z

commit c9a8bbb7704cbf515c0fc68970abbe4e91d68521 upstream. ACPICA uses acpi_hw_write_gpe_enable_reg() to re-enable a GPE after an event signaled by it has been handled. However, this function writes the entire GPE enable mask to the GPE's enable register which may not be correct. Namely, if one of the other GPEs in the same register was previously enabled by acpi_enable_gpe() and subsequently disabled using acpi_set_gpe(), acpi_hw_write_gpe_enable_reg() will re-enable it along with the target GPE. To fix this issue rework acpi_hw_write_gpe_enable_reg() so that it calls acpi_hw_low_set_gpe() with a special action value, ACPI_GPE_COND_ENABLE, that will make it only enable the GPE if the corresponding bit in its register's enable_for_run mask is set. Signed-off-by: Rafael J. Wysocki Signed-off-by: Len Brown Signed-off-by: Greg Kroah-Hartman

ACPI / ACPICA: Fix low-level GPE manipulation code

2010-08-02T17:30:20Z

commit fd247447c1d94a79d5cfc647430784306b3a8323 upstream. ACPICA uses acpi_ev_enable_gpe() for enabling GPEs at the low level, which is incorrect, because this function only enables the GPE if the corresponding bit in its enable register's enable_for_run mask is set. This causes acpi_set_gpe() to work incorrectly if used for enabling GPEs that were not previously enabled with acpi_enable_gpe(). As a result, among other things, wakeup-only GPEs are never enabled by acpi_enable_wakeup_device(), so the devices that use them are unable to wake up the system. To fix this issue remove acpi_ev_enable_gpe() and its counterpart acpi_ev_disable_gpe() and replace acpi_hw_low_disable_gpe() with acpi_hw_low_set_gpe() that will be used instead to manipulate GPE enable bits at the low level. Make the users of acpi_ev_enable_gpe() and acpi_ev_disable_gpe() call acpi_hw_low_set_gpe() instead and make sure that GPE enable masks are only updated by acpi_enable_gpe() and acpi_disable_gpe() when GPE reference counters change from 0 to 1 and from 1 to 0, respectively. Signed-off-by: Rafael J. Wysocki Signed-off-by: Len Brown Signed-off-by: Greg Kroah-Hartman

ACPI: skip checking BM_STS if the BIOS doesn't ask for it

2010-08-02T17:30:11Z

commit 718be4aaf3613cf7c2d097f925abc3d3553c0605 upstream. It turns out that there is a bit in the _CST for Intel FFH C3 that tells the OS if we should be checking BM_STS or not. Linux has been unconditionally checking BM_STS. If the chip-set is configured to enable BM_STS, it can retard or completely prevent entry into deep C-states -- as illustrated by turbostat: http://userweb.kernel.org/~lenb/acpi/utils/pmtools/turbostat/ ref: Intel Processor Vendor-Specific ACPI Interface Specification table 4 "_CST FFH GAS Field Encoding" Bit 1: Set to 1 if OSPM should use Bus Master avoidance for this C-state https://bugzilla.kernel.org/show_bug.cgi?id=15886 Signed-off-by: Len Brown Signed-off-by: Greg Kroah-Hartman

acpi: Support IBM SMBus CMI devices

2010-03-24T13:38:37Z

On some old IBM workstations and desktop computers, the BIOS presents in the DSDT an SMBus object that is missing the HID identifier that the i2c-scmi driver looks for. Modify the ACPI device scan code to insert the missing HID if it finds an IBM system with such an object. Affected machines: IntelliStation Z20/Z30. Note that the i2c-i801 driver no longer works on these machines because of ACPI resource conflicts. Signed-off-by: Darrick J. Wong Signed-off-by: Jean Delvare

ACPI: processor: export acpi_get_cpuid()

2010-03-15T01:17:18Z

Rename static get_cpu_id() to acpi_get_cpuid() and export it. This change also gives us an opportunity to remove the #ifndef CONFIG_SMP from processor_driver.c and into a header file where it properly belongs. Acked-by: Venkatesh Pallipadi Signed-off-by: Alex Chiang Signed-off-by: Len Brown

ACPI: processor: mv processor_pdc.c processor_core.c

2010-03-15T01:17:17Z

We've renamed the old processor_core.c to processor_driver.c, to convey the idea that it can be built modular and has driver-like bits. Now let's re-create a processor_core.c for the bits needed statically by the rest of the kernel. The contents of processor_pdc.c are a good starting spot, so let's just rename that file and complete our three card monte. Acked-by: Venkatesh Pallipadi Signed-off-by: Alex Chiang Signed-off-by: Len Brown

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/percpu

2010-03-03T15:34:18Z

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/percpu: percpu: add __percpu sparse annotations to what's left percpu: add __percpu sparse annotations to fs percpu: add __percpu sparse annotations to core kernel subsystems local_t: Remove leftover local.h this_cpu: Remove pageset_notifier this_cpu: Page allocator conversion percpu, x86: Generic inc / dec percpu instructions local_t: Move local.h include to ringbuffer.c and ring_buffer_benchmark.c module: Use this_cpu_xx to dynamically allocate counters local_t: Remove cpu_local_xx macros percpu: refactor the code in pcpu_[de]populate_chunk() percpu: remove compile warnings caused by __verify_pcpu_ptr() percpu: make accessors check for percpu pointer in sparse percpu: add __percpu for sparse. percpu: make access macros universal percpu: remove per_cpu__ prefix.

Merge branch 'acpica' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6

2010-03-01T18:36:22Z

* 'acpica' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6: ACPI: replace acpi_integer by u64 ACPICA: Update version to 20100121. ACPICA: Remove unused uint32_struct type ACPICA: Disassembler: Remove obsolete "Integer64" field in parse object ACPICA: Remove obsolete ACPI_INTEGER (acpi_integer) type ACPICA: Predefined name repair: fix NULL package elements ACPICA: AcpiGetDevices: Eliminate unnecessary _STA calls ACPICA: Update all ACPICA copyrights and signons to 2010 ACPICA: Update for new gcc-4 warning options

x86/PCI: use host bridge _CRS info by default on 2008 and newer machines

2010-02-23T17:43:42Z

The main benefit of using ACPI host bridge window information is that we can do better resource allocation in systems with multiple host bridges, e.g., http://bugzilla.kernel.org/show_bug.cgi?id=14183 Sometimes we need _CRS information even if we only have one host bridge, e.g., https://bugs.launchpad.net/ubuntu/+source/linux/+bug/341681 Most of these systems are relatively new, so this patch turns on "pci=use_crs" only on machines with a BIOS date of 2008 or newer. Signed-off-by: Bjorn Helgaas Signed-off-by: Jesse Barnes

PCI / ACPI / PM: Platform support for PCI PME wake-up

2010-02-23T00:21:02Z

Although the majority of PCI devices can generate PMEs that in principle may be used to wake up devices suspended at run time, platform support is generally necessary to convert PMEs into wake-up events that can be delivered to the kernel. If ACPI is used for this purpose, PME signals generated by a PCI device will trigger the ACPI GPE associated with the device to generate an ACPI wake-up event that we can set up a handler for, provided that everything is configured correctly. Unfortunately, the subset of PCI devices that have GPEs associated with them is quite limited. The devices without dedicated GPEs have to rely on the GPEs associated with other devices (in the majority of cases their upstream bridges and, possibly, the root bridge) to generate ACPI wake-up events in response to PME signals from them. Add ACPI platform support for PCI PME wake-up: o Add a framework making is possible to use ACPI system notify handlers for run-time PM. o Add new PCI platform callback ->run_wake() to struct pci_platform_pm_ops allowing us to enable/disable the platform to generate wake-up events for given device. Implemet this callback for the ACPI platform. o Define ACPI wake-up handlers for PCI devices and PCI root buses and make the PCI-ACPI binding code register wake-up notifiers for all PCI devices present in the ACPI tables. o Add function pci_dev_run_wake() which can be used by PCI drivers to check if given device is capable of generating wake-up events at run time. Developed in cooperation with Matthew Garrett . Signed-off-by: Rafael J. Wysocki Signed-off-by: Jesse Barnes