linux/drivers/usb/host, branch v3.11.3

usb: ehci-mxc: check for pdata before dereferencing

2013-09-27T00:21:39Z

commit f375fc520d4df0cd9fcb570f33c103c6c0311f9e upstream. Commit 7e8d5cd93fac ("USB: Add EHCI support for MX27 and MX31 based boards") introduced code that could potentially lead to a NULL pointer dereference on driver removal. Fix this by checking for the value of pdata before dereferencing it. Signed-off-by: Daniel Mack Reported-by: Dan Carpenter Signed-off-by: Greg Kroah-Hartman

USB: OHCI: Allow runtime PM without system sleep

2013-09-27T00:21:38Z

commit 69820e01aa756b8d228143d997f71523c1e97984 upstream. Since ohci-hcd supports runtime PM, the .pm field in its pci_driver structure should be protected by CONFIG_PM rather than CONFIG_PM_SLEEP. Without this change, OHCI controllers won't do runtime suspend if system suspend or hibernation isn't enabled. Signed-off-by: Alan Stern Signed-off-by: Greg Kroah-Hartman

xhci: fix port BESL LPM capability checking

2013-09-27T00:21:37Z

commit dcf06a036848b4e8e6c8220f2e00b9adf6f84918 upstream. Wrong capability bit was checked for best effort service latency. bit 20 indicate port is BESL LPM capable (BLC), bit 19 is hardware LPM capable (HLC) This patch should be backported to kernels as old as 3.11, that contain the commit a558ccdcc71c7770c5e80c926a31cfe8a3892a09 "usb: xhci: add USB2 Link power management BESL support" Signed-off-by: Mathias Nyman Signed-off-by: Sarah Sharp Reported-by: Steve Cotton Signed-off-by: Greg Kroah-Hartman

usb: xhci: Disable runtime PM suspend for quirky controllers

2013-09-27T00:21:37Z

commit c8476fb855434c733099079063990e5bfa7ecad6 upstream. If a USB controller with XHCI_RESET_ON_RESUME goes to runtime suspend, a reset will be performed upon runtime resume. Any previously suspended devices attached to the controller will be re-enumerated at this time. This will cause problems, for example, if an open system call on the device triggered the resume (the open call will fail). Note that this change is only relevant when persist_enabled is not set for USB devices. This patch should be backported to kernels as old as 3.0, that contain the commit c877b3b2ad5cb9d4fe523c5496185cc328ff3ae9 "xhci: Add reset on resume quirk for asrock p67 host". Signed-off-by: Shawn Nematbakhsh Signed-off-by: Sarah Sharp Signed-off-by: Greg Kroah-Hartman

xhci-plat: Don't enable legacy PCI interrupts.

2013-09-27T00:21:37Z

commit 52fb61250a7a132b0cfb9f4a1060a1f3c49e5a25 upstream. The xHCI platform driver calls into usb_add_hcd to register the irq for its platform device. It does not want the xHCI generic driver to register an interrupt for it at all. The original code did that by setting the XHCI_BROKEN_MSI quirk, which tells the xHCI driver to not enable MSI or MSI-X for a PCI host. Unfortunately, if CONFIG_PCI is enabled, and CONFIG_USB_DW3 is enabled, the xHCI generic driver will attempt to register a legacy PCI interrupt for the xHCI platform device in xhci_try_enable_msi(). This will result in a bogus irq being registered, since the underlying device is a platform_device, not a pci_device, and thus the pci_device->irq pointer will be bogus. Add a new quirk, XHCI_PLAT, so that the xHCI generic driver can distinguish between a PCI device that can't handle MSI or MSI-X, and a platform device that should not have its interrupts touched at all. This quirk may be useful in the future, in case other corner cases like this arise. This patch should be backported to kernels as old as 3.9, that contain the commit 00eed9c814cb8f281be6f0f5d8f45025dc0a97eb "USB: xhci: correctly enable interrupts". Signed-off-by: Sarah Sharp Reported-by: Yu Y Wang Tested-by: Yu Y Wang Reviewed-by: Felipe Balbi Signed-off-by: Greg Kroah-Hartman

USB: OHCI: fix build error related to ohci_suspend/resume

2013-08-26T22:22:15Z

Commit 9a11899c5e69 (USB: OHCI: add missing PCI PM callbacks to ohci-pci.c) added missing ohci_suspend and ohci_resume callback pointers, but forgot that these callbacks are declared and defined only when CONFIG_PM is enabled. This patch adds a preprocessor conditional to avoid build errors when PM is disabled. Reported-by: Guenter Roeck Tested-by: Guenter Roeck Reported-by: Meelis Roos , Signed-off-by: Alan Stern Signed-off-by: Greg Kroah-Hartman

USB: OHCI: add missing PCI PM callbacks to ohci-pci.c

2013-08-23T17:41:46Z

Commit c1117afb8589 (USB: OHCI: make ohci-pci a separate driver) neglected to preserve the entries for the pci_suspend and pci_resume driver callbacks. As a result, OHCI controllers don't work properly during suspend and after hibernation. This patch adds the missing callbacks to the driver. Signed-off-by: Alan Stern Reported-and-tested-by: Steve Cotton Signed-off-by: Greg Kroah-Hartman

USB: EHCI: accept very late isochronous URBs

2013-08-12T20:45:26Z

Since commits 4005ad4390bf (EHCI: implement new semantics for URB_ISO_ASAP) and c75c5ab575af (ALSA: USB: adjust for changed 3.8 USB API) became widely distributed, people have been experiencing problems with audio transfers. The slightest underrun causes complete failure, requiring the audio stream to be restarted. It turns out that the current isochronous API doesn't handle underruns in the best way. The ALSA developers would much rather have transfers that are submitted too late be accepted and complete in the normal fashion, rather than being refused outright. This patch implements the requested approach. When an isochronous URB submission is so late that all its scheduled slots have already expired, a debugging message will be printed in the log and the URB will be accepted as usual. Assuming it was submitted by a completion handler (which is normally the case), it will complete shortly thereafter with all the usb_iso_packet_descriptor status fields marked -EXDEV. This fixes (for ehci-hcd) https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1191603 It should be applied to all kernels that include commit 4005ad4390bf. Signed-off-by: Alan Stern Tested-by: Maksim Boyko CC: Clemens Ladisch CC: Signed-off-by: Greg Kroah-Hartman

usb: xhci: add missing dma-mapping.h includes

2013-07-31T18:27:18Z

A randconfig build hit the following build errors because xhci.c and xhci-mem.c use dma mapping functions but don't include . Add the missing includes to fix the build errors. drivers/usb/host/xhci.c In function 'xhci_gen_setup': drivers/usb/host/xhci.c +4872 : error: implicit declaration of function 'dma_set_mask' drivers/usb/host/xhci.c +4872 : error: implicit declaration of function 'DMA_BIT_MASK' drivers/usb/host/xhci-mem.c In function 'xhci_free_stream_ctx': drivers/usb/host/xhci-mem.c +435 : error: implicit declaration of function 'dma_free_coherent' drivers/usb/host/xhci-mem.c In function 'xhci_alloc_stream_ctx': drivers/usb/host/xhci-mem.c +463 : error: implicit declaration of function 'dma_alloc_coherent' Signed-off-by: James Hogan Cc: Greg Kroah-Hartman Cc: linux-usb@vger.kernel.org Signed-off-by: Sarah Sharp

xhci: fix null pointer dereference on ring_doorbell_for_active_rings

2013-07-25T15:10:09Z

in some cases where device is attched to xhci port and do not responding, for example ath9k_htc with stalled firmware, kernel will crash on ring_doorbell_for_active_rings. This patch check if pointer exist before it is used. This patch should be backported to kernels as old as 2.6.35, that contain the commit e9df17eb1408cfafa3d1844bfc7f22c7237b31b8 "USB: xhci: Correct assumptions about number of rings per endpoint" Signed-off-by: Oleksij Rempel Signed-off-by: Sarah Sharp Cc: stable@vger.kernel.org