linux/drivers/tty/serial, branch v2.6.39

drivercore: revert addition of of_match to struct device

2011-05-18T18:32:23Z

Commit b826291c, "drivercore/dt: add a match table pointer to struct device" added an of_match pointer to struct device to cache the of_match_table entry discovered at driver match time. This was unsafe because matching is not an atomic operation with probing a driver. If two or more drivers are attempted to be matched to a driver at the same time, then the cached matching entry pointer could get overwritten. This patch reverts the of_match cache pointer and reworks all users to call of_match_device() directly instead. Signed-off-by: Grant Likely

serial/imx: read cts state only after acking cts change irq

2011-04-19T23:36:25Z

If cts changes between reading the level at the cts input (USR1_RTSS) and acking the irq (USR1_RTSD) the last edge doesn't generate an irq and uart_handle_cts_change is called with a outdated value for cts. The race was introduced by commit ceca629 ([ARM] 2971/1: i.MX uart handle rts irq) Reported-by: Arwed Springer Tested-by: Arwed Springer Cc: stable@kernel.org # 2.6.14+ Signed-off-by: Uwe Kleine-König Signed-off-by: Greg Kroah-Hartman

Merge branch 'sh-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6

2011-04-07T19:48:45Z

* 'sh-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6: sh: select ARCH_NO_SYSDEV_OPS. sh: fix build error in board-sh7757lcr.c sh: landisk: Remove whitespace sh: landisk: Remove mv_nr_irqs sh: sh-sci: Fix double initialization by serial_console_setup serial: sh-sci: prevent setup of uninitialized serial console dma: shdma: add checking the DMAOR_AE in sh_dmae_err

Merge branch 'for-linus2' of git://git.profusion.mobi/users/lucas/linux-2.6

2011-04-07T18:14:49Z

* 'for-linus2' of git://git.profusion.mobi/users/lucas/linux-2.6: Fix common misspellings

Fix common misspellings

2011-03-31T14:26:23Z

Fixes generated by 'codespell' and manually reviewed. Signed-off-by: Lucas De Marchi

Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux-2.6 into sh-latest

2011-03-31T06:39:47Z

sh: sh-sci: Fix double initialization by serial_console_setup

2011-03-31T05:33:24Z

The driver is initialized in a state with an unknown value by serial_console_setup. And initialization fails. This is caused by the initialization by sci_console_init. This function does not seem to be necessary for the present sh-sci driver. Signed-off-by: Nobuhiro Iwamatsu Signed-off-by: Paul Mundt

serial: sh-sci: prevent setup of uninitialized serial console

2011-03-31T05:33:22Z

Commit 906b17dc089f7fa87e37a9cfe6ee185efc90e0da introduced a condition where the kernel will crash unless a earlyprintk parameter is specified. Without this parameter, sci_console_init is called during early console setup without any port being initialized, and the kernel crashes a little bit later when uart_set_options attemps to invoke set_termios on a port with an ops member equal to NULL. This patch just checks in sci_console_init that the port is properly initialized, and aborts the early console setup if it is not. Signed-off-by: Alexandre Courbot Signed-off-by: Paul Mundt

apbuart: Depend upon sparc.

2011-03-31T04:12:24Z

It absolutely needs to be able to get at pdev_archdata members which are sparc specific. Signed-off-by: David S. Miller Reported-by: Stephen Rothwell

sparc32,leon: Fixed APBUART frequency detection

2011-03-30T11:28:54Z

The UARTs may be located on different APB buses, thus have different UART clock frequency. The system frequency is not the same (but often) as the UART frequency, rather the APB bus frequency that the APBUART is located at has the same frequency, so this looks at the "freq" property instead. Signed-off-by: Daniel Hellstrom Signed-off-by: David S. Miller