linux/drivers/input/serio, branch v3.3-rc2

module_param: make bool parameters really bool (drivers & misc)

2012-01-12T23:02:20Z

module_param(bool) used to counter-intuitively take an int. In fddd5201 (mid-2009) we allowed bool or int/unsigned int using a messy trick. It's time to remove the int/unsigned int option. For this version it'll simply give a warning, but it'll break next kernel version. Acked-by: Mauro Carvalho Chehab Signed-off-by: Rusty Russell

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input

2012-01-12T20:40:41Z

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: Input: bcm5974 - set BUTTONPAD property Input: serio_raw - return proper result when serio_raw_write fails Input: serio_raw - really signal HUP upon disconnect Input: serio_raw - remove stray semicolon Input: revert some over-zealous conversions to module_platform_driver()

Input: serio_raw - return proper result when serio_raw_write fails

2012-01-11T07:13:57Z

If serio_raw_write was always returning number of bytes successfully sent to serio port and never signalled error condition to the caller. Change it so that for completely failed transfers appropriate error code returned to the caller (partially successful writes still return number of bytes transferred). Reported-by: Che-liang Chiou Signed-off-by: Dmitry Torokhov

Input: serio_raw - really signal HUP upon disconnect

2012-01-11T07:13:21Z

Commit 8c1c10d5706bbb3b41cb4a5578339d67d3eeffc2 attempted to signal POLLHUP | POLLERR condition when polling disconnected device, unfortunately it did not do it quite correctly. Reported-by: Che-Liang Chiou Signed-off-by: Dmitry Torokhov

Input: serio_raw - remove stray semicolon

2012-01-11T07:13:00Z

Signed-off-by: Che-Liang Chiou Signed-off-by: Dmitry Torokhov

Input: revert some over-zealous conversions to module_platform_driver()

2012-01-11T07:12:46Z

Recent conversion to module_platform_driver() went a bit too far and converted not only drivers that used platform_driver_register() but also ones using platform_driver_probe(), breaking them in process. Reported-by: Geert Uytterhoeven Signed-off-by: Dmitry Torokhov

Merge branch 'next' of git://git.monstr.eu/linux-2.6-microblaze

2012-01-11T01:37:49Z

* 'next' of git://git.monstr.eu/linux-2.6-microblaze: microblaze: Wire-up new system calls microblaze: Remove NO_IRQ from architecture input: xilinx_ps2: Don't use NO_IRQ block: xsysace: Don't use NO_IRQ microblaze: Trivial asm fix microblaze: Fix debug message in module microblaze: Remove eprintk macro microblaze: Send CR before LF for early console microblaze: Change NO_IRQ to 0 microblaze: Use irq_of_parse_and_map for timer microblaze: intc: Change variable name microblaze: Use of_find_compatible_node for timer and intc microblaze: Add __cmpdi2 microblaze: Synchronize __pa __va macros

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input

2012-01-10T18:55:52Z

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (64 commits) Input: tc3589x-keypad - add missing kerneldoc Input: ucb1400-ts - switch to using dev_xxx() for diagnostic messages Input: ucb1400_ts - convert to threaded IRQ Input: ucb1400_ts - drop inline annotations Input: usb1400_ts - add __devinit/__devexit section annotations Input: ucb1400_ts - set driver owner Input: ucb1400_ts - convert to use dev_pm_ops Input: psmouse - make sure we do not use stale methods Input: evdev - do not block waiting for an event if fd is nonblock Input: evdev - if no events and non-block, return EAGAIN not 0 Input: evdev - only allow reading events if a full packet is present Input: add driver for pixcir i2c touchscreens Input: samsung-keypad - implement runtime power management support Input: tegra-kbc - report wakeup key for some platforms Input: tegra-kbc - add device tree bindings Input: add driver for AUO In-Cell touchscreens using pixcir ICs Input: mpu3050 - configure the sampling method Input: mpu3050 - ensure we enable interrupts Input: mpu3050 - add of_match table for device-tree probing Input: sentelic - document the latest hardware ... Fix up fairly trivial conflicts (device tree matching conflicting with some independent cleanups) in drivers/input/keyboard/samsung-keypad.c

Merge branch 'amba-modalias' of git://ftp.arm.linux.org.uk/pub/linux/arm/kernel/git-cur/linux-2.6-arm

2012-01-07T02:03:30Z

* 'amba-modalias' of git://ftp.arm.linux.org.uk/pub/linux/arm/kernel/git-cur/linux-2.6-arm: sound: aaci: Enable module alias autogeneration for AMBA drivers watchdog: sp805: Enable module alias autogeneration for AMBA drivers fbdev: amba: Enable module alias autogeneration for AMBA drivers serial: pl011: Enable module alias autogeneration for AMBA drivers serial: pl010: Enable module alias autogeneration for AMBA drivers spi: pl022: Enable module alias autogeneration for AMBA drivers rtc: pl031: Enable module alias autogeneration for AMBA drivers rtc: pl030: Enable module alias autogeneration for AMBA drivers mmc: mmci: Enable module alias autogeneration for AMBA drivers input: ambakmi: Enable module alias autogeneration for AMBA drivers gpio: pl061: Enable module alias autogeneration for AMBA drivers dmaengine: pl330: Enable module alias autogeneration for AMBA drivers dmaengine: pl08x: Enable module alias autogeneration for AMBA drivers hwrng: nomadik: Enable module alias autogeneration for AMBA drivers ARM: amba: Auto-generate AMBA driver module aliases during modpost ARM: amba: Move definition of struct amba_id to mod_devicetable.h

input: xilinx_ps2: Don't use NO_IRQ

2012-01-05T07:34:30Z

Drivers shouldn't use NO_IRQ. Microblaze and PPC define NO_IRQ as 0 and this reference will be removed in near future. Signed-off-by: Michal Simek Reviewed-by: Ryan Mallon Acked-by: Grant Likely CC: Rob Herring