linux/drivers/input/misc/rb532_button.c, branch v3.10.25

Input: remove use of __devexit

2012-11-24T08:05:38Z

CONFIG_HOTPLUG is going away as an option so __devexit is no longer needed. Signed-off-by: Bill Pemberton Acked-by: Mark Brown Signed-off-by: Dmitry Torokhov

Input: remove use of __devinit

2012-11-24T08:05:19Z

CONFIG_HOTPLUG is going away as an option so __devinit is no longer needed. Signed-off-by: Bill Pemberton Acked-by: Mark Brown Acked-by: Javier Martinez Canillas Signed-off-by: Dmitry Torokhov

Input: remove use of __devexit_p

2012-11-24T08:03:48Z

CONFIG_HOTPLUG is going away as an option so __devexit_p is no longer needed. Signed-off-by: Bill Pemberton Acked-by: Russell King Signed-off-by: Dmitry Torokhov

Input: misc - use macro module_platform_driver()

2011-12-01T07:41:42Z

Commit 940ab88962bc1aff3273a8356d64577a6e386736 introduced a new macro to save some platform_driver boilerplate code. Use it. Signed-off-by: JJ Ding Signed-off-by: Dmitry Torokhov

Input: add driver for S1 button of rb532

2009-03-10T03:10:12Z

Mikrotik's Routerboard 532 has two builtin buttons, from which one triggers a hardware reset. The other one is accessible through GPIO pin 1. Sadly, this pin is being multiplexed with UART0 input, so enabling it as interrupt source (as implied by the gpio-keys driver) is not possible unless UART0 has been turned off. The later one though is a rather bad idea as the Routerboard is an embedded device with only a single serial port, so it's almost always used as serial console device. This patch adds a driver based on INPUT_POLLDEV, which disables the UART and reconfigures GPIO pin 1 temporarily while reading the button state. This procedure works fine and has been tested as part of another, unpublished driver for this device. Signed-off-by: Phil Sutter Signed-off-by: Dmitry Torokhov