linux/drivers/ata/Kconfig, branch v3.14

ATA: SATA_MV: Add missing Kconfig select statememnt

2014-01-29T18:19:47Z

SATA_MV depends on GENERIC_PHY. So if SATA_MV is built in, GENERIC_PHY cannot be modular. Fixes build error found by kbuild test robot. Signed-off-by: Andrew Lunn Signed-off-by: Tejun Heo

ahci_imx: depend on CONFIG_MFD_SYSCON

2013-07-26T12:57:56Z

ahci_imx makes use of regmap but the dependency wasn't specified in Kconfig leading build failures if CONFIG_AHCI_IMX is enabled but CONFIG_MFD_SYSCON is not. Add the Kconfig dependency. Signed-off-by: Tejun Heo Reported-by: Stephen Rothwell

ahci_imx: add ahci sata support on imx platforms

2013-07-24T16:29:08Z

imx6q contains one Synopsys AHCI SATA controller, But it can't share ahci_platform driver with other controllers because there are some misalignments of the generic AHCI controller - the bits definitions of the HBA registers, the Vendor Specific registers, the AHCI PHY clock and the AHCI signals adjustment window(GPR13 register). - CAP_SSS(bit20) of the HOST_CAP is writable, default value is '0', should be configured to be '1' - bit0 (only one AHCI SATA port on imx6q) of the HOST_PORTS_IMPL should be set to be '1'.(default 0) - One Vendor Specific register HOST_TIMER1MS(offset:0xe0) should be configured regarding to the frequency of AHB bus clock. - Configurations of the AHCI PHY clock, and the signal parameters of the GPR13 Setup its own ahci sata driver, contained the imx6q specific initialized codes, re-use the generic ahci_platform driver, and keep the generic ahci_platform driver clean as much as possible. tj: patch description reformatted Signed-off-by: Richard Zhu Reviewed-by: Shawn Guo Signed-off-by: Tejun Heo

libata: make it clear that sata_inic162x is experimental

2013-07-22T21:11:14Z

sata_inic162x never reached a state where it's reliable enough for production use and data corruption is a relatively common occurrence. Make the driver generate warning about the issues and mark the Kconfig option as experimental. If the situation doesn't improve, we'd be better off making it depend on CONFIG_BROKEN. Let's wait for several cycles and see if the kernel message draws any attention. Signed-off-by: Tejun Heo Reported-by: Martin Braure de Calignon Reported-by: Ben Hutchings Reported-by: risc4all@yahoo.com

Merge branch 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus

2013-07-13T21:52:21Z

Pull MIPS updates from Ralf Baechle: "MIPS updates: - All the things that didn't make 3.10. - Removes the Windriver PPMC platform. Nobody will miss it. - Remove a workaround from kernel/irq/irqdomain.c which was there exclusivly for MIPS. Patch by Grant Likely. - More small improvments for the SEAD 3 platform - Improvments on the BMIPS / SMP support for the BCM63xx series. - Various cleanups of dead leftovers. - Platform support for the Cavium Octeon-based EdgeRouter Lite. Two large KVM patchsets didn't make it for this pull request because their respective authors are vacationing" * 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (124 commits) MIPS: Kconfig: Add missing MODULES dependency to VPE_LOADER MIPS: BCM63xx: CLK: Add dummy clk_{set,round}_rate() functions MIPS: SEAD3: Disable L2 cache on SEAD-3. MIPS: BCM63xx: Enable second core SMP on BCM6328 if available MIPS: BCM63xx: Add SMP support to prom.c MIPS: define write{b,w,l,q}_relaxed MIPS: Expose missing pci_io{map,unmap} declarations MIPS: Malta: Update GCMP detection. Revert "MIPS: make CAC_ADDR and UNCAC_ADDR account for PHYS_OFFSET" MIPS: APSP: Remove SSB: Kconfig: Amend SSB_EMBEDDED dependencies MIPS: microMIPS: Fix improper definition of ISA exception bit. MIPS: Don't try to decode microMIPS branch instructions where they cannot exist. MIPS: Declare emulate_load_store_microMIPS as a static function. MIPS: Fix typos and cleanup comment MIPS: Cleanup indentation and whitespace MIPS: BMIPS: support booting from physical CPU other than 0 MIPS: Only set cpu_has_mmips if SYS_SUPPORTS_MICROMIPS MIPS: GIC: Fix gic_set_affinity infinite loop MIPS: Don't save/restore OCTEON wide multiplier state on syscalls. ...

MIPS: OCTEON: Rename Kconfig CAVIUM_OCTEON_REFERENCE_BOARD to CAVIUM_OCTEON_SOC

2013-06-10T16:01:25Z

CAVIUM_OCTEON_SOC most place we used to use CPU_CAVIUM_OCTEON. This allows us to CPU_CAVIUM_OCTEON in places where we have no OCTEON SOC. Remove CAVIUM_OCTEON_SIMULATOR as it doesn't really do anything, we can get the same configuration with CAVIUM_OCTEON_SOC. Signed-off-by: David Daney Cc: linux-mips@linux-mips.org Cc: linux-ide@vger.kernel.org Cc: linux-edac@vger.kernel.org Cc: linux-i2c@vger.kernel.org Cc: netdev@vger.kernel.org Cc: spi-devel-general@lists.sourceforge.net Cc: devel@driverdev.osuosl.org Cc: linux-usb@vger.kernel.org Acked-by: Greg Kroah-Hartman Acked-by: Wolfram Sang Acked-by: Mauro Carvalho Chehab Patchwork: https://patchwork.linux-mips.org/patch/5295/ Signed-off-by: Ralf Baechle

libata: do not limit R-Car SATA driver to shmobile

2013-05-24T02:33:40Z

The motivation for this is to allow the driver to be used with the r8a7790 SoC. I believe that rather than adding another SoC to the list of allowed SoCs it is better to simply remove the dependency of the driver on shmobile all together. Signed-off-by: Simon Horman Signed-off-by: Tejun Heo

[libata] Avoid specialized TLA's in ZPODD's Kconfig

2013-03-04T22:12:46Z

ODD is not a common TLA for non-ATA people so they will get confused by its meaning when they are configuring the kernel. This patch fixed this problem by using ODD only after stating what it is. Signed-off-by: Aaron Lu Signed-off-by: Jeff Garzik

Merge tag 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev

2013-02-25T01:32:15Z

Pull libata updates from Jeff Garzik: 1) apply, and then revert, the sysfs export of ATA host controller number. Discussion was continuing after patch application, trying to figure out how to best mesh exported data with the installers, boot-time agents and other parties that want this info. 2) Merge Zero-Power Optical Device Driver (ZPODD) support, bringing the wonderfulness of sane power management to your CD/DVD device. Includes one SCSI-subsystem patch (with appropriate ACKs), adding runtime PM support to 'sr' driver. That is the ZPODD interaction bits. Patchset went through some 13 revisions before it got here; kudos to Intel for persistence. 3) pata_samsung_cf: use devm_clk_get() 4) more ata_piix, ahci PCI IDs 5) Add SATA driver for R-Car SoC 6) Convert libata to use devm_ioremap_resource (Note: I think Greg sent this to you, also) 7) Set proper Sense Key (SK) in the SCSI simulator when ATA passthrough indicates check condition. Google and specification hawks everywhere shall rejoice. * tag 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev: (22 commits) [libata] fix smatch warning for zpodd_wake_dev [libata] Set proper SK when CK_COND is set. [libata] Convert to devm_ioremap_resource() libata: add R-Car SATA driver ahci: Add Device IDs for Intel Wellsburg PCH ata_piix: Add Device IDs for Intel Wellsburg PCH [SCSI] remove can_power_off flag from scsi_device [libata] scsi: no poll when ODD is powered off [SCSI] sr: support runtime pm ahci: AHCI-mode SATA patch for Intel Avoton DeviceIDs ata_piix: IDE-mode SATA patch for Intel Avoton DeviceIDs [libata] PM code cleanup for ata port [libata] pm: differentiate system and runtime pm for ata port Revert "libata: export host controller number thru /sys" libata: do not suspend port if normal ODD is attached libata: expose pm qos flags for ata device libata: handle power transition of ODD libata: check zero power ready status for ZPODD libata: move acpi notification code to zpodd libata: identify and init ZPODD devices ...

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/s390/linux

2013-02-22T01:54:03Z

Pull s390 update from Martin Schwidefsky: "The most prominent change in this patch set is the software dirty bit patch for s390. It removes __HAVE_ARCH_PAGE_TEST_AND_CLEAR_DIRTY and the page_test_and_clear_dirty primitive which makes the common memory management code a bit less obscure. Heiko fixed most of the PCI related fallout, more often than not missing GENERIC_HARDIRQS dependencies. Notable is one of the 3270 patches which adds an export to tty_io to be able to resize a tty. The rest is the usual bunch of cleanups and bug fixes." * 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/s390/linux: (42 commits) s390/module: Add missing R_390_NONE relocation type drivers/gpio: add missing GENERIC_HARDIRQ dependency drivers/input: add couple of missing GENERIC_HARDIRQS dependencies s390/cleanup: rename SPP to LPP s390/mm: implement software dirty bits s390/mm: Fix crst upgrade of mmap with MAP_FIXED s390/linker skript: discard exit.data at runtime drivers/media: add missing GENERIC_HARDIRQS dependency s390/bpf,jit: add vlan tag support drivers/net,AT91RM9200: add missing GENERIC_HARDIRQS dependency iucv: fix kernel panic at reboot s390/Kconfig: sort list of arch selected config options phylib: remove !S390 dependeny from Kconfig uio: remove !S390 dependency from Kconfig dasd: fix sysfs cleanup in dasd_generic_remove s390/pci: fix hotplug module init s390/pci: cleanup clp page allocation s390/pci: cleanup clp inline assembly s390/perf: cpum_cf: fallback to software sampling events s390/mm: provide PAGE_SHARED define ...