1 files changed, 34 insertions, 0 deletions
diff --git a/docs/HowToBuildOnARM.rst b/docs/HowToBuildOnARM.rst
new file mode 100644
index 0000000000..6f9ac4adc0
--- /dev/null
+++ b/docs/HowToBuildOnARM.rst
@@ -0,0 +1,34 @@
+.. _how_to_build_on_arm:
+
+===================================================================
+How To Build On ARM
+===================================================================
+
+.. sectionauthor:: Wei-Ren Chen (陳韋任) <chenwj@iis.sinica.edu.tw>
+
+Introduction
+============
+
+This document contains information about building/testing LLVM and
+Clang on ARM.
+
+Notes On Building LLVM/Clang on ARM
+=====================================
+Here are some notes on building/testing LLVM/Clang on ARM. Note that
+ARM encompasses a wide variety of CPUs; this advice is primarily based
+on the ARMv6 and ARMv7 architectures and may be inapplicable to older chips.
+
+#. If you are building LLVM/Clang on an ARM board with 1G of memory or less,
+   please use ``gold`` rather then GNU ``ld``.
+   Building LLVM/Clang with ``--enable-optimized``
+   is prefered since it consumes less memory. Otherwise, the building
+   process will very likely fail due to insufficient memory. In any
+   case it is probably a good idea to set up a swap partition.
+
+#. If you want to run ``make
+   check-all`` after building LLVM/Clang, to avoid false alarms (eg, ARCMT
+   failure) please use the following configuration:
+
+   .. code-block:: bash
+
+     $ ../$LLVM_SRC_DIR/configure --with-abi=aapcs